Zanussi ZBB28441SA User Manual page 13

4mm
44mm
3
Adjust the appli-
ance in the niche.
Make sure that the
distance between the
appliance and the
cupboard front-edge
is 44 mm.
The lower hinge cov-
er (in the accessories
bag) makes sure that
the distance between
the appliance and the
kitchen furniture is
correct.
Make sure that the
clearance between
the appliance and the
cupboard is 4 mm.
Open the door. Put
the lower hinge cover
in position.
5
Remove the cor-
rect part from the
hinge cover (E). Make
sure to remove the
part DX, in the case
of right hinge, SX in
opposite case.
www.zanussi.com
I
I
4
Attach the appli-
ance to the niche
with 4 screws.
C
D
E
E
B
6
Attach the covers
(C, D) to the lugs and
the hinge holes.
Install the vent grille
(B).
Attach the hinge cov-
ers (E) to the hinge.
G H
7
Connect the ap-
pliance laterally to the
kitchen furniture side-
wall:
1. Loosen the
screws of the
part (G) and
move the part
(G) till the furni-
ture sidewall.
2. Tighten the
screws of the
part (G) again.
3. Attach the part
(H) to the part
(G).
~50 mm
o
90
21 mm
o
90
~50 mm
21 mm
9
Install the part
(Ha) on the inner side
of the kitchen furni-
ture.
Ha Hb
Hc Hd
8
Disconnect the
parts (Ha), (Hb), (Hc)
and (Hd).
Ha
Hc
10
Push the part (Hc)
on the part (Ha).
13