Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZBB2294L
Summary of Contents for Zanussi ZBB2294L
- Page 1 User manual Fridge-Freezer ZBB2294R ZBB2294L...
-
Page 2: Table Of Contents
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Operation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 What to do if…... - Page 3 or damaged power plug may overheat and cause a Care and cleaning fire. • Before maintenance, switch off the appliance and dis- 3. Make sure that you can come to the mains plug of connect the mains plug from the mains socket. the appliance.
-
Page 4: Operation
Environment Protection insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations This appliance does not contain gasses which could to obtain from your local authorities. Avoid damaging the damage the ozone layer, in either its refrigerant cir- cooling unit, especially at the rear near the heat exchang- cuit or insulation materials. -
Page 5: Helpful Hints And Tips
Important! In the event of accidental defrosting, for Important! Do not use metallic instruments to remove the example due to a power failure, if the power has been off trays from the freezer. for longer that the value shown in the technical Movable shelves characteristics chart under "rising time", the defrosted food must be consumed quickly or cooked immediately... -
Page 6: Care And Cleaning
For safety, store in this way only one or two days at the • do not allow fresh, unfrozen food to touch food which most. is already frozen, thus avoiding a rise in temperature of Cooked foods, cold dishes, etc..: these should be covered the latter;... -
Page 7: What To Do If
Defrosting of the refrigerator 3. Leave the door open and insert the Frost is automatically eliminated from the evaporator of plastic scraper in the refrigerator compartment every time the motor com- the appropriate pressor stops, during normal use. The defrost water seating at the bot- drains out through a trough into a special container at the tom centre, placing... - Page 8 Problem Possible cause Solution The appliance does not operate. The appliance is switched off. Switch on the appliance. The lamp does not operate. The mains plug is not connected to the Connect the mains plug to the mains mains socket correctly. socket correctly.
-
Page 9: Technical Data
Replacing the lamp power and specifically designed for household appli- ances (the maximum power is shown on the lamp Caution! Disconnect the plug from the mains cover). socket. 4. Install the lamp cover. 1. Remove the screw 5. Tighten the screw to the lamp cover. from the lamp cov- 6. - Page 10 The appliance must be earthed. The power supply cable This appliance complies with the E.E.C. Directives. plug is provided with a contact for this purpose. If the do- Door reversibility mestic power supply socket is not earthed, connect the The door of the appliance opens to the right. If you want to appliance to a separate earth in compliance with current open the door to the left, do these steps before you install regulations, consulting a qualified electrician.
- Page 11 44mm Install the appliance in the Adjust the appliance in the Attach the appliance to the If necessary cut the adhe- sive sealing strip and then niche. niche. niche with 4 screws. Push the appliance in the Make sure that the distance apply it to the appliance as shown in figure.
-
Page 12: Environmental Concerns
ca. 50 mm 8 mm 8 mm 90° 21 mm 90° ca. 50 mm 21 mm Push the part (Hc) on the Open the appliance door Remove the brackets and Install the part (Ha) on the part (Ha). and the kitchen furniture mark a distance of 8 mm inner side of the kitchen door at an angle of 90°. - Page 16 www.zanussi.com/shop...