Sony DVP-NS67P Operating Instructions Manual page 40

Notes
• While playing a Super VCD on which the audio
track 2 is not recorded, no sound will come out
when you select "2:STEREO," "2:1/L," or
"2:2/R."
• When playing in DVD-VR mode: If you connect
to an audio component using the DIGITAL OUT
(COAXIAL) jack and want to switch between the
sound tracks, set "DOLBY DIGITAL" to "D-
PCM" in "AUDIO SETUP" (page 55).
Checking the audio signal
format
You can check the audio signal format by
pressing AUDIO repeatedly during playback.
The format of the current audio signal (Dolby
Digital, DTS, PCM, etc.) appears as shown
below.
◆When playing a DVD VIDEO
Example:
Dolby Digital 5.1 ch
1 : ENGLISH DOLBY DIGITAL
Front (L/R)
+ Center
◆When playing a DivX video file on a DATA
CD or DATA DVD
Example:
MP3 audio
1:
MP3 128k
About audio signals
Audio signals recorded in a disc contain the
sound elements (channels) shown below.
Each channel is output from a separate
speaker.
• Front (L)
• Front (R)
• Center
• Rear (L)
• Rear (R)
• Rear (Monaural): This signal can be either
the Dolby Surround Sound processed
signals or the Dolby Digital sound's
monaural rear audio signals.
• LFE (Low Frequency Effect) signal
40
Rear (L/R)
3 / 2 .1
LFE (Low Frequency
Effect)
Bit rate
Note
If "DTS" is set to "OFF" in "AUDIO SETUP"
(page 56) the DTS track selection option will not
appear on the screen even if the disc contains DTS
tracks.