Advertisement
II. INSTALL MOUNTING BRACKETS ONTO ENCLOSURE
1. S-10 I Sonoma
A Position enclosure upright
B Locate two horizontal dimples on each side of the enclosure
C Screw in the mounting brackets through the dimples using the (4)
supplied pilot point wafer head screws
III. TEST SUBWOOFER ENCLOSURE
2. Full Size Trucks
A Position enclosure so speaker faces up
B Locate the two dimples on the each side so the brackets will
attach as shown in diagram below
C Screw in the mounting brackets through the dimples using the (4)
supplied pilot point wafer head screws
STEP 1: Locate Subwoofer Enclosure
A Place enclosure into vehicle,
- against rear wall of truck behind the driver seat (S-10
I
Sonoma)
- under the rear folding seat on the drivers side, the speaker face down (Full size trucks)
B Run Clarion extension harness and plug into harness connector on subwoofer enclosure
C Ground black wire on Clarion harness to vehicle (be sure to use wire wheel or sand paper to clean metal of any paint or residue)
STEP
2:
Test Subwoofer Enclosure;
also test radio functions (fade, balance, etc)
$-10 Truck
- 3 -
Full size Truck
Advertisement
