Advertisement
la. WIRING USING A CLARION "T" HARNESS
I
There are
2
methods to connect this product to the vehicle. Please refer to section la and Ib for each.
STEP 1: Remove the Radio
STEP
4: Connect the amplifier ground wire to a clean chassis ground
near the subwoofer enclosure
STEP
5:
TEST and SET the GAIN.
Turn on the system and be sure all
speakers are working properly
STEP
2:
Connect the "T" Harness
A Unplug factory wires from radio
B Plug the "T" harness in line with the radio wiring
(SEE DIAGRAM 1 )
C Connect the BLACK wire on "T" harness to radio chassis
STEP
3: Route the wire harness from the radio to;
- behind the driver seat (S-10 / Sonoma)
- under the rear seat. drivers side (Full size trucks)
Set the subwoofer amplifier gain to
a suitable level
Using
a
Clarion "T" HARNESS
CONNECT
TO RADIO
CHASSIS
EXTENSION
FACTORY RADIO
(DIAG.1)
GAIN ADJUSTMENT
-,f-----_ll:-. . . . . . .
CONNECT TO GROUND
lb. WIRING USING THE SUPPLIED HARNESS
STEP
1:
Remove the Radio
STEP
2:
Connect the wires
Yellow: Connect to Constant 12V Power
Black: Connect to Radio Ground or Chassis
BluelWhite: Connect to Amp/Antenna Turn-on Lead
Green: Connect to Left Rear Speaker (+) Positive Lead
Green/Black: Connect to Left Rear Speaker (-) Negative Lead
Violet: Connect to Right Rear Speaker (+) Pqsitive Lead
Violet/Black: Connect to Right Rear Speaker (-) Negative Lead
STEP
3: Route the wire harness from the radio to
- behind the driver seat (S-10 / Sonoma)
- under the rear seat drivers side (Full size trucks)
STEP
4: Connect the amplifier ground wire to ground near the
subwoofer enclosure
STEP
5:
TEST and SET the GA/N
Turn on the system and be sure all
speakers are working properly
Set the subwoofer amplifier gain to a suitable level
Using the Supplied Harness
FACTORY RADIO or
AFTERMARKET RADIO
(DIAG.2)
- 2-
CONNECT TO GROUND
Advertisement
