LG LDS5540ST Owner's Manual page 9

CONTROL PANEL
Display varies by model(LDS5560)
Cycle Options
Press the desired cycle and then select the options for that
cycle.
RINSE
Repeated pressing of the Rinse button will select the desired
Rinse option. The Sanitary, Extra Rinse, or Sanitary and Extra
Rinse lights will show in the bottom left portion of the dis-
play.
SANITARY ( )
This high-temperature rinse sanitizes dishes and glassware in
accordance with NSF/ANSI Standard 184 for residential dish-
washers. Certified dishwashers are not intended for licensed
food establishments.
EXTRA RINSE ( R )
+
The Extra Rinse symbol indicates that an extra rinse has been
added to the cycle. An extra rinse can help reduce hard water
spotting on dishes. To add an extra rinse, press the Rinse but-
ton repeatedly until the Extra Rinse symbol appears in the
display.
SPRAY (INTENSITY)
First, select the desired cycle. Press the Spray button repeat-
edly until the desired spray intensity is selected.
Soft ( ), Medium (
HALF LOAD ( )
For small loads, you may use just the upper or lower rack to
save energy. Each press of the Half Load button cycles be-
tween upper rack only and lower rack only.
DELAY START
The Delay Start feature allows you to delay the start of a se-
lected cycle. Each time the Delay Start button is pressed, the
delay time will increase an hour. The delay start time can be
set from 1 to 19 hours, in one-hour increments.
POWER
Press the Power button to turn on the control panel. If no cycle
is selected within four minutes, the dishwasher will power off.
After the cycle is complete, the power automatically turns
off for safety and to reduce energy consumption. If there is a
power surge, power outage, or disruption of any kind, the PF
indicator will display and power will be automatically turned
off for safety. The cycle will need to be restarted.
), Strong ( )
PARTS AND FEATURES
EXTRA DRY ( )
Select the Extra Dry option for better drying performance.
This option adds 60 minutes of extra drying time to the cycle.
The Extra Dry button will illuminate when the option has
been selected.
Press and hold the Rinse and Spray buttons for three seconds.
TO CANCEL A CYCLE
To cancel a cycle, open the door and then press and hold
the Spray and Half Load buttons simultaneously for approxi-
mately three seconds. The drain pump will activate and the
cycle will cancel. The display will show "dr" and the dish-
washer will drain the water. After the dishwasher is drained,
the power will turn off.
If power is turned on and no cycle has been selected, the
dishwasher will power off within four minutes.
CHILD LOCK
The Child Lock feature helps prevent your settings from be-
ing changed during a cycle. Selecting this feature locks all
of the buttons, except for the Power button, on the control
panel. This feature does not lock the door.
To activate the Child Lock:
1. Press the Power button.
2. Select the cycle (and desired options).
3. Press and hold the Half Load and Delay Start buttons for
three seconds. The Child Lock indicator will illuminate in
the display once the Child Lock is activated.
4. Close the door to begin the cycle.
CHIME ON/OFF
To enable or disable the chime, first, turn on the dishwasher.
Press and hold the Spray and Delay Start buttons simultane-
ously for approximately three seconds.
DIGITAL DISPLAY
The Digital Display on the control panel shows the ESTIMAT-
ED cycle time. When the dishwasher is powered up, the dis-
play will be blank. When the cycle and options are selected,
the display will show the total estimated time to complete
those selections. During operation, the display shows the re-
maining estimated operating time.
9