1. Manuals
  2. Brands
  3. TP-Link Manuals
  4. Network Router
  5. SafeStream TL-R480T+
  6. Installation manual

TP-Link TL-R480T+ Installation Manual

Load balance broadband router
Hide thumbs Also See for TL-R480T+:
Table of Contents

Advertisement

Quick Links

Download this manual See also: User Manual
Инструкция для
TP-Link TL-R480T+
Перейти в карточку товара
8 800 775 98 98

Advertisement

Table of Contents
loading

Related Manuals for TP-Link TL-R480T+

Summary of Contents for TP-Link TL-R480T+

  • Page 1 Инструкция для TP-Link TL-R480T+ Перейти в карточку товара 8 800 775 98 98...
  • Page 2 Enterprise Networking Solution Installation Guide Load Balance Broadband Router...
  • Page 3 Specifications are subject to change without notice. is a registered trademark of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks of their respective holders. No part of the specifications may be reproduced in any form or by any means or used to make any derivative such as translation, transformation, or adaptation without permission from TP-LINK TECHNOLOGIES CO., LTD.

  • Page 4: Chapter 1 Introduction

    The User Guide of this product is provided in the resource CD. To obtain the latest product information, please visit the Official Website: http://www.tp-link.com This Installation Guide describes the hardware characteristics, installation methods and the points that should be attended to during installation. This Installation Guide is structured as follows: Chapter 1 Introduction.
  • Page 5 Chapter 1 Introduction ——————————— 01 Product Overview ..............01 Appearance ................01 Chapter 2 Installation ———————————— 03 Package Contents ..............03 Safety Precautions ..............03 Installation Tools..............05 Product Installation ..............06 Chapter 3 Lightning Protection ———————— 08 Cabling Reasonably..............08 Connect to Ground..............10 Equipotential Bonding ............11 Use Lightning Arrester ............12 Chapter 4 Connection ———————————...

  • Page 6: Front Panel

    WAN ports to satisfy various Internet access requirements through one device. At the same time, network traffic is managed to ensure that data is properly distributed to each port. TP-LINK TL-R480T+ will provide you consistent network uptime and reliable Ethernet connectivity.

  • Page 7: Rear Panel

    Interface Description Interface Description The WAN port is designed to connect the Router to the interface provided by ISP via the RJ45 cable The LAN port is designed to connect the Router to the local PCs or switches by the RJ45 cable The Console port is designed to connect with the serial port of a computer Console or terminal to check and monitor some simple system information of the...

  • Page 8: Chapter 2 Installation

    Make sure that the package contains the following items. If any of the listed items is damaged or missing, please contact your distributor. One Router One Power Cord, One Console This Installation Guide Cable and One Ethernet Cable One Resource CD Two mounting brackets and the To avoid any device damage and bodily injury caused by improper use, please observe the following rules.
  • Page 9 Site Requirements Temperature/Humidity Please keep a proper temperature and humidity in the equipment room. Too high/low humidity may lead to bad insulation, electricity leakage, mechanical property changes and corrosions. Too high temperature may accelerate aging of the insulation materials and can thus significantly shorten the service life of the device. For normal temperature and humidity of the device, please check the following table.

  • Page 10: Chapter 3 Lightning Protection

    Lightening Protection Extremely high voltage currents can be produced instantly when lightning occurs and the air in the electric discharge path can be instantly heated up to 20,000 . As this instant current is strong enough to damage electronic devices, more effective lightning protection measures should be taken.

  • Page 11: Desktop Installation

    Note: These tools are not provided with our product. If needed, please self purchase them. Desktop Installation To install the device on the desktop, please follow the steps: Set the device on a flat surface strong enough to support the entire weight of the device with all fittings.
  • Page 12 After the brackets are attached to the device, use suitable screws (not provided) to secure the brackets to the rack, as illustrated in the following figure. Rack Figure 2-3 Rack Installation Caution: Please set 5~10cm gaps around the device for air circulation. Please avoid any heavy thing placed on the device.
  • Page 13 In the actual network environment, you may need cable outdoors and indoors, and the requirements for cabling outdoors and indoors are different. A reasonable cabling system can decrease the damage of induced lightning to devices. Note: It's not recommended using Ethernet cables outdoors. When cabling outdoors, please use a signal lightning arrester.
  • Page 14 Requirements for Cabling Indoors When cabling indoors, keep a certain distance away from the devices that may cause high-frequency interferences, such as down-conductor cable, powerline, power transformer and electromotor. The main cable should be paved in the metal raceway of the access shaft. When cabling, keep the loop area formed by the cable itself as small as possible.
  • Page 15 Parallel cabling 2~5kVA One is in the grounded metal raceway or metal pipe powerline The both are in the grounded metal raceway or metal pipe Parallel cabling >5kVA One is in the grounded metal raceway or metal pipe powerline The both are in the grounded metal raceway or metal pipe Device Min Distance (m)

  • Page 16: Equipotential Bonding

    Note: The grounding bar and the ground cable are not provided with our product. If needed, please self purchase them. Connecting to the Ground via the Power Supply If the device is installed in the normal environment, the device can be grounded via the PE (Protecting Earth) cable of the AC power supply as shown in the following figure.
  • Page 17 Grounding Terminal Equipotential Bonding Cable Ground Cable Grounding Bar Figure 3-3 Equipotential Bonding When equipotential bonding, please note that the cable should be copper wrapped Kelly with its area being 6mm at least. The shorter cable the better, and use a grounding bar to establish an equipotential bonding point.
  • Page 18 Signal lightning arrester is used to protect RJ45 ports of the device from lightning. When cabling outdoors, please install a signal lightning arrester before connecting the cable to the device. When purchasing or using a signal lightning arrester, please observe the following rules: The port rate of the signal lightning arrester should match the rate of the desired port on the device.
  • Page 19 Please connect the WAN port of the Router to the interface provided by ISP via Ethernet cable. Connect a LAN port of the Router to the computer by RJ45 cable as the following figure shown. LAN Port RJ45 Cable RJ45 Port Figure 4-1 Connecting the LAN Port CLI (Command Line Interface) enables you to do some simple operations to the Router,...
  • Page 20 Note: The console port is the first port on the right of the front panel. Please keep the device power off when you plugging the console cable. Do not connect the console port with other ports by RJ45 cable. After completing the installation, please verify the following items: There are 5~10cm of clearance around the sides of the device for ventilation and the air flow is adequate.
  • Page 21 Connect a PC to a LAN port of the Router with a RJ45 cable properly. Set the Internet Protocol (TCP/IP) properties of the PC with the "IP address" as 192.168.0.x ("x" is any number from 2 to 254), "Subnetmask" as 255.255.255.0 and "Default gateway"...

  • Page 22: Chapter 4 Connection

    After a successful login, the Quick Setup screen will pop up as the Figure 5-4 shown. If it does not prompt, you can click the Quick Setup on the left of the main menu. Then click Next. Figure 5-4 Quick Setup Select the total number of WAN ports you prefer to use as the Figure 5-5 shown.
  • Page 23 Figure 5-8 WAN Connection Type - PPPoE Click Next to dial up, and the process will take a few minutes. The process of configuring the network parameters is shown as Figure 5-9. If you close the screen during the process, the configuration will still be continued in the background. These fields are case sensitive.

  • Page 24: Login

    If you have difficulty in this process, please contact your ISP. Figure 5-12 WAN Connection Type - Static IP Connecting After that, you will see the next screen. Click Finish to complete the quick installation or click Continue to configure other WAN ports. Figure 5-13 Configuration Completed After a successful login, the main page will appear as the following figure, and you...
  • Page 25 You can restore the Router to factory defaults, please refer to 1.2 Appearance of this Installation Guide for detail. The default management address of the Router is http://192.168.0.1, default username and password are both admin. All your current settings will be cleared after the Router is restored.
  • Page 26 Item Content Standards and Protocol IEEE 802.3, IEEE 802.3u, TCP/ IP, DHCP, ICMP, NAT, PPPoE, SNTP, HTTP, DNS Transmission Medium 10Base-T: UTP/STP of Cat. 3 or above 100Base-TX: UTP/STP of Cat. 5 or above LEDs PWR, SYS, Link/Act, 100Mbps Operating Temperature 0 ~ 40 -40 ~ 70 Storage Temperature 10% ~ 90%RH Non-condensing...
  • Page 27 For more help, please go to: www.tp-link.com/support/faq.asp To download the latest Firmware, Driver, Utility and User Guide, please go to: www.tp-link.com/support/download.asp For all other technical support, please contact us by using the following details: Global Tel: +86 755 26504400 E-mail: support@tp-link.com...
  • Page 28 Germany/Austria Tel: +49 1805 875465 (German Service)/+49 1805 TPLINK E-mail: support.de@tp-link.com Fee: 0.14 EUR/min from the German fixed phone network and up to 0.42 EUR/min from mobile phone Service time: Monday to Friday 9:00 AM to 6:00 PM GMT+ 1 or GMT+ 2 (Daylight Saving Time in Germany)
  • Page 29 Website: http://www.tp-link.com E-mail: support@tp-link.com 7106503825 Rev: 2.0.0...
  • Page 30 TP-Link TL-R480T+ Описание Характеристики...

Table of Contents