Table of Contents
Advertisement
1.
After each use, wipe the Air Hammer with a clean cloth to remove any dirt
and grease buildup.
2.
To maintain tool life, always lubricate the air line by adding a few drops of
pneumatic tool oil to the air line (or Air Inlet) before each use. Or, install the
automatic oiler-filter system as illustrated on page 5.
3.
Before each use, drain water out of the air compressor tank and
condensation from the air lines. Refer to the Air Compressor Operation
Manual.
4.
Periodically check and clean out the Cylinder chisel hole.
5.
Before each use, check the chisels for cracks, breaks, or any unusual signs
of wear. Do not use if damaged.
Item
1.
Body
2.
Rubber Gasket
3.
O-ring
4.
Regulator
5.
Control Pin
6.
O-ring
7.
Ball
8.
Spring
9.
Air Inlet
10.
Rear Valve
NOTE: Some parts are listed and shown for illustration purposes only and
are not available individually as replacement parts.
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE
BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR
THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT,
THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL RE-
PAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK
AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT
OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLA-
TION OF REPLACEMENT PARTS THERETO.
SKU 92037
Maintenance
Parts List
Description
PLEASE READ THE FOLLOWING CAREFULLY
For technical questions, please call 1-800-444-3353
Qty
Item
Description
1
11.
Valve Disk
1
12.
Front Valve
2
13.
Piston
1
14.
Cylinder
1
15.
Retainer Spring
1
16.
Trigger
1
17.
Pin
1
18.
Pin
1
19.
Chisel, Flat
1
20.
Chisel, Pointed
Qty
1
1
1
1
1
1
1
1
1
1
Page 7
Advertisement
Table of Contents
