Advertisement
BOUNDARY COMPENSATION
DIPOLE/BIPOLE
In the BIPOLE position the two side firing drivers are engaged and
are operating in phase with each other. In the DIPOLE position the
side drivers are active, but are wired out of phase from each other.
The resulting sound field is even more expansive, and can create an
even larger effect than the bi-pole mode.
HIGH FREQUENCY EQUALIZATION
In rooms without carpets and drapes, the CUT position will
improve the sound.
6
o w n e r s m a n u a l
PAINTING THE BEZEL AND THE GRILLEE
Note: The inner section of the cardboard cutout template
acts as a paint mask if you choose to paint the grille while it
is installed.
The grille incorporates a scrim cloth to hide the domes and cones
of the loudspeaker components when installed. This scrim-cloth
must be removed before painting. It is tacked into place in the four
corners of the grille. To remove, gently peel from each corner in
turn. Reserve the scrim-cloth until the grille is painted and dry.
If you are using a spray gun, set it for the most diffused spray and
try two very thin coats. If you are using a brush, thin the paint so
that the grille holes will not be blocked.
After the paint is dry, apply four or five small, thin spots of spray
adhesive (similar to 3M Super 77) around the edge of the scrim
cloth. Starting with one edge, work the scrim-cloth back into
place, making sure that the cloth is stretched flat behind the grille.
INSTALLING THE GRILLE
8.
Fit the grille into the bezel gradually. Work in a circular
fashion, gradually fitting the grille into the bezel. If you have
any trouble fitting the grille in, check the dog screws. If they
are too tight, they can warp the bezel. Once fully installed, the
grille is absolutely flush with the bezel.
Advertisement
