Table of Contents
Advertisement
II. Installation and Operating Instructions
1. This icemaker must be installed in accordance with applicable national, state,
and local regulations.
2. CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews
are securely in place after installation. Make sure that none have fallen into
the dispenser unit/storage bin.
A. Checks Before Installation
• Visually inspect the exterior of the shipping container and immediately report any
damage to the carrier. Upon opening the container, any concealed damage should
also be immediately reported to the carrier.
• Remove the shipping carton, tape, and packing material. If any are left in the icemaker,
it will not work properly.
• Remove the panels to prevent damage when installing the icemaker. See "II.B. How to
Remove Panels."
• Remove the package containing the accessories.
• Remove the protective plastic film from the panels. If the icemaker is exposed to the
sun or to heat, remove the film after the icemaker cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• See the nameplate on the rear panel, and check that your voltage supplied
corresponds with the voltage specified on the nameplate.
• This icemaker can be installed on a dispenser unit or storage bin 30" wide or wider.
The following are recommended: Hoshizaki Dispenser, Model DB-200 or DM series;
Hoshizaki Ice Storage Bin, Model B-500 series.
B. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screws.
Lift up and towards you.
• Top Panel: Lift up at front slightly,
push rearward, and lift off.
• Side Panel (R): Remove the screw.
Slide forward slightly and lift off.
• Insulation Panel (A): Lift up slightly,
and pull towards you.
• Top Insulation: Lift off.
WARNING
Top Insulation
Insulation Panel (A)
Front Panel
Screws
9
Top Panel
Side
Frame
Screw
Side Panel (R)
Fig. 1
Advertisement
Table of Contents
