Cisco DPC3829 User Manual page 32

Chapter 2 Installing the D OC SIS Wireless Residential Gateway
Choose a location so that there is plenty of room to guide the cables away from

the residential gateway without straining or crimping them.
Choose a location that allows adequate ventilation around the residential

gateway.
How Do I Mount the Wireless Residential Gateway on a Wall? (Optional)
Your residential gateway may include mounting holes so that, if you wish, you can
mount the residential gateway to a wall. This section describes how to mount the
residential gateway to a wall, and includes a list of the equipment that you will need
along with suggestions for choosing an appropriate place to mount the residential
gateway.
Select an Appropriate Place to Mount the Wireless Residential Gateway
You may mount the residential gateway to a wall that is made of cement, wood, or
drywall. When choosing an appropriate mounting place, refer to the following
recommendations:
Ensure that the mounting location is free of obstructions on all sides, and the

cables should be able to easily reach the residential gateway without strain.
Leave sufficient clearance between the bottom of the residential gateway and any

flooring or shelving underneath to allow access to cabling.
Allow enough slack in all cables so that the residential gateway can be removed

for any required maintenance without disconnecting the cables.
Choose a location that allows adequate ventilation around the residential

gateway.
Equipment Needed
Verify that you have the following items that you will need to mount the residential
gateway:
Two wall anchors for #8 x 1-inch screws

Two #8 x 1-inch pan head sheet metal screws

Drill with a 3/16-in. wood or masonry bit, as appropriate for the wall

composition
A copy of the wall-mounting slots illustration shown on the following pages

14 OL-30545-01-01