USB CAPTURE FOR MAC COMPUTER
Copy the folder "Mac Driver" into Mac hard disk, open the folder and double-click Empia 1.0.0b2.
zip, the "setup" file appears. Follow dialog-box messages, click "next" and finish installation.
Note: 1. Please connect Mac computer and visualiser when installing
2. Please use USB2.0 from visualiser accessories.
WORKING ON THE STAGE
1. Place your material on the working surface.
2. Select the enlargement required with the " T" and "W" keys.
3. Adjust the focus with the "Near" and "Far" keys or "AUTO" key.
WORKING OUTSIDE THE STAGE
For showing 3-dimensional objects, just place them on the working surface and adjust the " T" or
"W" and "AUTO" keys. If the object is too big for the stage or you want to show it from the side,
just place it behind or in front of the unit and tilt the camera by hand (please take off the
close-up lens first).
LIGHT
The arm lights are on when the power is on. Each time you press the "LAMP" buttons, the lighting
changes as below.
The arm lights turn on
The back light turns on
All the lights turn off
ADJUSTING IMAGE SIZE
In order to reduce or enlarge the image size displayed on the screen, press the " T" or "W" button.
WORKING WITH NEGATIVES
The visualiser is automatically set to display normal materials on the screen when the power is on.
To display negatives, turn on the backlight by pressing the "LAMP" key, and then press the "Neg"
button to display the film negatives. Press the "Neg" button again to display normal materials in the
colour mode.
Rotate 330 degrees
vertically