Grease - ProForm 14.0 CE User Manual

4. Tip: Avoid pinching the Wire Harness (60).
Insert the Upright (5) into the Main Frame (1).
Attach the Upright (5) with four M8 x 16mm
Screws (102) and four M8 Split Washers (103);
do not tighten the Screws yet.
5. Using a small plastic bag to keep your
fingers clean, apply a coat of the included
grease to the Upright Axle (48) and to two Wave
Washers (118).
Tip: Avoid damaging the Wire Harness (60).
Insert the Upright Axle (48) through the Upright
(5) and center it. Slide a Wave Washer (118)
onto each side of the Upright Axle.
Next, identify the Right and Left Upper Body
Legs (6, 7), which are marked with “"Right”" and
“"Left”" stickers, and orient them as shown.
Slide the Right and Left Upper Body Legs
(6, 7) onto the right and left sides of the Upright
Axle (48).
Tighten an M8 x 16mm Screw (102) and an M8
Washer (95) into each end of the Upright Axle
(48) at the same time.
4
Avoid pinching the
Wire Harness (60)
102
5
60
102
118
95
7

Grease

8
Meijer.com
5
102
103
60
1
102
103
103
102
Avoid damaging the
Wire Harness (60)
5
Grease
48
118
6
102
95