Listening To Ipad/Iphone/Ipod / Listening To Radio - iHome iDL100 Quick Start Manual

Sure Alarm
The unit has a sure alarm feature so the buzzer alarm still sound in the event of a power failure, if the backup battery is
installed (see page 7). If your iPad/iPhone/iPod has no sound for 35 seconds or is not present, the unit will switch to
buzzer alarm automatically.
Listening to iPad, iPhone or iPod Using the Docks or USB Port
This unit features two Lightning docks (located on top of the unit) exclusively to play and charge iOS devices equipped
with the latest Lightning connector. Dock 1 is for iPhone and iPod ONLY. There is also a USB port (located on back of
the unit) which can play and charge both older iOS devices (such as iPhone 4, iPad, etc.) AND Lightning devices using
the charging cable that came with the device.
Play and pause a device connected to the Lightning docks using the
play and pause a device connected to the USB port using the
Directions below apply to whichever dock/port you wish to control.
1. Connecting using the Lightning Docks:
Dock 1 Dock an already playing iPhone 5 or iPod touch 5th generation in Dock 1 on top of the unit. The unit will
automatically turn on and you will hear the audio playing from your iPhone/iPod.
Dock 2 Dock an already playing iPad mini, iPad 4th generation, iPhone 5 or iPod touch 5th generation in Dock 2
on top of the unit. The unit will automatically turn on and you will hear the audio playing from your iPad/iPhone/iPod.
NOTE: You may need to remove the skin or case on your device for proper dock connection.
Connecting using the USB port: Connect your iPad, iPhone or iPod to the USB port located on back of the unit using
the USB charging cable that came with it.
Note: If the audio source volume is too low on the iPad/iPhone/iPod, the unit may not detect that the iPad/iPhone/iPod is
in play mode. If so, pressing the
make it play.
2. When an iPhone/iPod is docked to the Lightning dock or connected to the USB port and in standby mode, press the
Dock 1 Button,
already on, press and release the Mode Button as needed until "Dock 1", "Dock 2" or "USB" appears on the lower part
of the display, indicating which dock/port on the unit is in iPod mode. If your iPad, iPhone or iPod touch is in video
mode, you may see the "locked" slider on the iPad/iPhone/iPod display. If so, you will need to unlock your
iPad/iPhone/iPod.
3. Press the Dock 1 Button,
again to resume play.
4. Press the + or – Button on the unit to go to the next or previous track. Press and hold while track is playing for high
speed forward or reverse music search of the current track.
Adjusting Sound on the Unit
You can adjust the sound on the unit while listening to any sound source.
1. Press the or Button on the unit to adjust the system volume.
2. Press and release the EQ Button as needed to select Treble, Bass, Balance or 3D sound effect, then press the + or
– Button to adjust settings.
TIP: You can also adjust EQ with the iHome Set app.
Setting up the Antenna
Extend FM wire antenna fully for best reception. Do not strip, alter or attach to other antennas.
Tuning and Playing the Radio
1. Press and release the Mode Button as needed to cycle through Dock 1, Dock 2, USB, FM radio and Aux-in modes.
2. When FM mode is selected, press the + or – Button to tune the radio to a desired station. The current radio frequency
appears in the lower right of the display. Press the + or – Button for a few seconds to scan for the next clear station.
Dock 1 Button,
Dock 2 Button or the
Dock 2 Button or the
USB Button. Only one device can play at a time.
Dock 2 Button or the
USB Button on the unit to play the iPad/iPhone/iPod. If the unit is
USB Button on the unit on the unit to pause play; press
Listening to Radio
5
Dock 1 Button or the
USB Button on the unit once should
Dock 2 Button and