MacNeil Pet Barrier Instruction Manual

5
STEP 5a
Center the assembled Pet Barrier in your vehicle with
the Threaded Rod Assembly portion on the floor and
extend it vertically until it is expanded snugly against the
roof and floor of the vehicle. Be sure the Vertical Tubes
are perpendicular to the floor. To secure the position,
turn the wing nuts until they are snug against the
Vertical Upright Tubes.
6
When the Pet Barrier is
adjusted to your satisfac-
tion, lock your adjustments
in place by installing the 4
Screws (H). Thread the
Screws through the thin
wall portion of the Plastic
Vertical Brackets (B).
Tighten firmly with your
phillips-head screwdriver.
STEP 5b
STEP 5a
STEP 5b
Once the barrier is firmly installed, you can optimize the func-
tion of your Pet Barrier by adjusting the Telescoping Hoop
Assemblies (A). First adjust the Telescoping Hoop
Assemblies by pushing or pulling them horizontally. Then you
can vertically optimize the position.
N O T E S
• This product is not to be used as a cargo barrier.
Any use of this product for that reason voids
warranty and releases manufacturer of any and
all liabilty.
• WeatherTech ® also offers the MW12N, an exten-
sion for the WeatherTech ®
height to vehicles with larger vertical cargo area.
• Check the Wing Nuts on the Vertical Tubes
periodically to adjust for settling.
P e t
Pet Barrier, to add
B a r r i e r

Instruction Manual