LG 50PG20 Training Manual page 95

Control Connector P111 to P102 on the Y
Control Connector P111 to P102 on the Y
LABELS P160 is a 60 Pin but the 50PG20
uses only 50 Pins P111 but P111 is
covered in Silicone so P160 pins are
used for description below.
CONNECTOR LABELS (Not Used)
P160 This connector is a little confusing in its
labeling.
This is a 60 Pin Connector to the Y-SUS board.
Example: The Labels outlined are on the silk
screening.
However, this connector has many more pins than
the Labels show.
Actual: Pin 1 through 10 of P160 are not used in this
model. Pins 17 through 21 are +5V .
Pins 23 through 60 are the Y-SUS drive signals.
There is a ground between each pin.
Roughly 39 pins dedicated to Y-SUS beginning at
pin 23.
Pin 1 on the Control PWB P111 is pin 50 on
the Y-SUS PWB P102
- SUS Slide 1 of 3 Label Explanation
- SUS Slide 1 of 3 Label Explanation
FL111 and FL112 5V Fuse
50 Pin
P111 CONNECTOR LABELS
(19 here is 49 on the connector)
Plasma Spring 2009
95
60 Pin
50PG20