Damper - LG WM3677HW Training Manual

COMBO
The dampers (3) support the tub at the bottom; it is supported by two springs at
the top and by the gasket on the front. Use special tool 383EER4003A. (See
photo, pages 47 and 66.) Hold in the locking tab so the pin will slide out.
WM3677 COMBO
MOTOR (continued)
1.
2.
3.
1.
2.
3.

DAMPER

1.
2.
Page 44 of 68
Remove the back cover.
Remove the large bolt (17 mm)
from the center of the rotor.
Pull the rotor off the shaft.
(You may have to wiggle it off.
The shaft is splined. When
replacing it, you may need a
helper to keep the drum from
being pushed forward so the
bolt will reach and can be
tightened.)
Remove the two screws from
the tub bracket.
Remove the six bolts on the
stator.
Remove the two electrical
connectors on the stator.
Remove the damper hinge
pins. (A special tool is available
5
for this. Using a /
socket makes this easier by
holding down the locking tab so
the pin slides out easily. )
Replace the damper with a new
part. Do not reuse a damper
that has been disassembled.
TRAINING MANUAL
" deep well
8