Table of Contents
Advertisement
Table of Contents
Main Menu
Driver's side
If you need to change a headlight
bulb on the driver's side, remove
the bolt from the battery hold-
down, and carefully push the
battery toward the windshield to
obtain enough working space.
BULB
HOLD
DOWN WIRE
CONNECTOR
2.
Remove the electrical connector
from the bulb by pulling the
connector straight back.
3.
Remove the rubber weather seal
by pulling on the tab.
4.
Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way, and remove the bulb.
Insert the new bulb into the hole,
5.
making sure the tabs are in their
slots. Pivot the hold-down wire
WEATHER
back in place, and clip the end into
SEAL
the slot.
6.
Install the rubber seal and make
sure it is right side up; it is marked
''TOP.''
7.
Push the electrical connector onto
the tabs of the new bulb. Make
sure it locks in place.
(Passenger's side)
8.
Install the power steering
reservoir on the bracket.
(Driver's side)
Pull the battery back to its original
position, then install the bolt in the
hold-down, and tighten it securely.
Lights
175
Maintenance
Advertisement
Chapters
Table of Contents
