Navigation Setup; External Device Control - Kenwood DNN991HD Instruction Manual

Return to the Top page
Setting Up

Navigation Setup

You can set navigation parameters.
1
Touch [ ] on any screen.
2
Touch [SETUP].
SETUP Menu screen appears.
3
Touch [Navigation].
Navigation SETUP screen appears.
4
Set each item as follows.
NAV Interrupt Speaker
Select speaker(s) used for voice guidance of
the navigation system.
Front L: Uses the front left side speaker for
voice guidance.
Front R: Uses the front right side speaker for
voice guidance.
Front All (Default): Uses both front speakers
for voice guidance.
NAV Voice Volume
Adjust the volume for voice guidance of the
navigation system. Default is "20".
NAV Mute
Mutes the volume of rear speakers during
voice guidance of the navigation system.
Default is "ON".
136

External Device Control

Control the external device power supply.
1
Touch [ ] on any screen.
2
Touch [EXT SW].
You can turn on or off the external device
power supply.
NOTE
• You must connect a commercially available relay
unit in order to use this function. Connect the
external device to be controlled to that relay unit.
EXT SW setup (P.133)
• See
setting the power on or off specification.
for information on