Table of Contents
Advertisement
TROUBLE
Insufficient lift capacity
Excessive wear on
cutting edge
Bucket cutting edge
not flat on the ground.
1595 01/11
© 2011 Alamo Group Inc.
OPERATION
POSSIBLE CAUSE
Load is greater than boom
lift capacity.
Improper hydraulic pump
operation.
Internal lift cylinder leakage.
Improper hydraulic valve
Bucket is riding on cutting
edge instead of wear runners.
Rear axle on tractor not level
from side to side.
Operation Section 4-43
POSSIBLE REMEDY
Check loader specifications.
Repair or replace pump.
Replace any worn parts and install
a seal repair kit. See "Cylinder
Service".
Repair or replace valve.
operation.
Use boom "FLOAT" position or
bucket level indicator to ensure
bucket rides on wear runners.
With tractor on level surface,
compare rear axle height from left
to right, measuring from axle center
to ground. Adjust air pressure in rear
tires until axle height measures the
same for both sides.
Advertisement
Table of Contents
