Hoover WindTunnel WindTunnel vacuum cleaner Owner's Manual page 4

1-5
A
Remove bag door on cleaner body
by pushing down at top of door and
pulling door outward.
Switch (A) above bag door should
be in OFF position.
1-8
Place nuts in recessed areas on
front of handle. Hold each nut in
place while tightening each bolt
securely with a Phillips screw driver.
STEP II Attach hose
1-11
A
B
Align end of hose with projections
(A) over slots (B) in dirt duct.
4
1-6
While holding rack in place, slide
handle onto cleaner body.
Make sure tab is inserted fully into
slot.
1-9
Reposition bag door by fitting tabs
on bottom of door into opening.
Press top of door to snap securely
shut.
NOTE: Hose must be connected as shown for all
operations.
1-12
B
Slide hose into (B) and twist hose to
lock it into place.
Lift hose tube cover (C).
1-7
Push bolts into holes on back of
handle.
1-10
Press cord into the 3 notches and
the clip as shown.
1-13
C
D
Position hose over rack and into
hose tube (D) or (E) (depening on
your model).
E