Mechanical Adjustment - Sony CDX-T67 Service Manual

• Elevator Height (Address) Adjustment
Note: This adjustments is necessary when the system controller (IC301),
variable resistor (RV302), lever (CHK.L) assy, lever (CHK.R) assy,
or chassis (EV) assy was replaced for any repair.
Connection:
power supply
(DC 14.4 V)
master unit
+
GND
RV302
SECTION 3

MECHANICAL ADJUSTMENT

BUS cable
compact disc changer
Adjustment Method:
1. Connect this set to the master unit (e.g. MDX-C7970/C7970R),
load a disc magazine, and place the set vertically as shown
below.
2. Connect the regulated power supply to the master unit, and
turn the power on.
3. Press the DISC button on the master unit and select DISC 6.
4. Adjust the variable resistor RV302 so that the reference holes
of the slider (6L) and of the chassis (6B) meet within an error
of ±0.15 mm when the tray is loaded at address 6.
chassis (6B)
slider (6L)
slider (6L)
(reference hole)
0.15mm
CDX-T67
slider (6L)
(reference hole)
chassis (6B)
(address 6 hole)
0.15mm
13