Page 1
12 V DC car battery (negative earth) Supplied accessories Disc magazine (1) Parts for installation and connections (1 set) Design and specifications subject to change without notice. COMPACT DISC CHANGER Sony Corporation 9-870-272-15 2002G0500-1 e Vehicle Company C 2002.07 Published by Sony Engineering Corporation...
DE FONCTIONNEMENT. NE REMPLACER CES COM- which have the “CAUTION LABEL” attached, please be sure to POSANTS QUE PAR DES PIÈCES SONY DONT LES put a new CAUTION LABEL (3-223-913-11) to the chassis (U.S) NUMÉROS SONT DONNÉS DANS CE MANUEL OU sub assy.
CDX-T67 SECTION 1 This section is extracted from instruction manual. GENERAL TABLE OF CONTENTS Inserting a disc Insertion d un disque Einlegen von CDs Een disc inbrengen Inserimento di un disco Labeled surface up With the arrow side facing up...
• Utilizzare solo le viti in dotazione. To the car audio (the master unit) compatible with the Sony Bus or the source selector • Pour garantir la sécurité de l’installation, utiliser beschädigt werden. Achten Sie auch darauf, daß die •...
CDX-T67 SECTION 2 DISASSEMBLY • This set can be disassembled in the order shown below. 2-1. DISASSEMBLY FLOW Note 1: The process described in can be performed in any order. Note 2: Without completing the process described in , the next process can not be performed.
CDX-T67 Note: Follow the disassembly procedure in the numerical order given. 2-2. FRONT PANEL (S) ASSY, CASE (UPPER S) 3 screw (PTT2.6 × 6) 4 case (upper S) 5 lever (FLT. 838) 1 screw (PTT2.6 × 6) 3 screw (PTT2.6 × 6) 2 front panel (S) assy 5 lever (FLT.
CDX-T67 2-6. MAIN BOARD 3 three screws (FP) 2 Remove three solders of the slide variable resistor (RV301). 4 main board 1 main flexible board 2 Remove two solders (CN101) of the elevator motor lead wires (M104). 2-7. ESCUTCHEON (S), SLIDE VARIABLE RESISTOR (ELEVATOR HEIGHT SENSOR) (RV301)
CDX-T67 2-14. LEVER (CHK.L) ASSY, LEVER (CHK.R) ASSY 3 Move the lever (CHK.L) assy fully in the direction of arrow A . 4 lever (CHK.L) assy 1 screw (P1.7 × 2.2) leaf spring (D retainer R) 2 joint (CHK) 3 Move the lever (CHK.R) assy fully in the direction of arrow A .
CDX-T67 SECTION 3 MECHANICAL ADJUSTMENT • Elevator Height (Address) Adjustment Adjustment Method: Note: This adjustments is necessary when the system controller (IC301), variable resistor (RV302), lever (CHK.L) assy, lever (CHK.R) assy, 1. Connect this set to the master unit (e.g. MDX-C7970/C7970R), or chassis (EV) assy was replaced for any repair.
CDX-T67 SECTION 4 ELECTRICAL CHECK Note: Focus Bias Check 1. This check is performed with the set placed horizontally. 2. Power supply voltage: DC14.4 V (more than 3 A). Connection: 3. Be sure to use the disc “YEDS-18” parts code: 3-702-101-01, but only –...
Page 15
CDX-T67 Tracking Offset Check Connection: – RF Board (Component Side) – oscilloscope (DC range) – TP (TE) IC101 TP (VC) Procedure: 1. Connect the oscilloscope to TP (TE) and TP (VC) on the RF board. 2. Put the set into play mode by loading the disc (YEDS-18).
ELVON 24 RESET SIGNAL RESET GENERATOR IC204 CN902 (2/2) IC901 REGULATOR µCOM B+ B. UP Q205, 206 BUS INTERFACE (FOR SONY BUS) IC201 DATA UNI SI DATA UNI SO UNI CK BUSON OUT BUSON BUSON BUSON OUT BUSON IN RESET...
CDX-T67 Ver 1.1 5-5. SCHEMATIC DIAGRAM – RF Board – • • See page 19 for Waveforms. See page 27 for IC Block Diagrams. Q101 C110 2SB624T1-BV345 C111 R119 AUTOMATIC 6.3V POWER CONTROL R127 RF AMP, FOCUS/TRACKING C107 ERROR AMP...
Serial data reading clock signal output to the CXD3017Q (IC401) SENS Internal status signal (sense signal) input from the CXD3017Q (IC401) BUSON Bus on/off control signal input from the SONY bus interface (IC201) “H”: bus on Battery detection signal input “L”: battery on BUCHK...
Page 31
70 to 74 Two-way data bus with the S-RAM Not used (open) RAMIO3 System reset signal input from the SONY bus interface (IC201) and reset signal generator (IC204) RESET “L”: reset For several hundreds msec. after the power supply rises, “L” is input, then it changes to “H”...
Page 32
CDX-T67 Pin No. Pin Name Description Chucking end detect switch (SW102) input terminal SAVE SW “L”: When completion of the disc chucking, loading or save operation Chucking end detect switch (SW102) input terminal LOAD SW “L”: When completion of the disc chucking, loading or save operation...
CDX-T67 Ver 1.4 SECTION 6 EXPLODED VIEWS NOTE: • -XX and -X mean standardized parts, so they • Items marked “*” are not stocked since they The components identified by mark 0 or dotted line with mark 0 are may have some difference from the original are seldom required for routine service.
CDX-T67 Ver 1.1 6-3. MECHANISM DECK SECTION-2 (MG-276A-159) M101 not supplied not supplied M103 The components identified by Les composants identifiés par une mark 0 or dotted line with marque 0 sont critiques pour la mark 0 are critical for safety.
CDX-T67 Ver 1.1 SECTION 7 JACK MAIN ELECTRICAL PARTS LIST NOTE: • Due to standardization, replacements in the • Items marked “*” are not stocked since they The components identified by mark 0 or dotted line with mark parts list may be different from the parts speci- are seldom required for routine service.
Page 37
CDX-T67 Ver 1.1 MAIN Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark D213 8-719-071-34 DIODE RB521S-30-TE61 R508 1-216-813-11 METAL CHIP 1/16W < IC > R509 1-216-845-11 METAL CHIP 100K 1/16W R510 1-216-845-11 METAL CHIP 100K 1/16W...
Page 41
CDX-T67 US Model Canadian Model SERVICE MANUAL AEP Model UK Model E Model Ver 1.2 2001.06 SUPPLEMENT-1 File this supplement with the service manual. Subject: Change of MAIN/JACK/RF boards. (Suffix-12) (ECN-CSA04865/CSB02866) In this set, RF, MAIN and JACK boards have been changed in the mid- way of production.
CDX-T67 1. NEW/FORMER TYPE DISCRIMINATION – JACK BOARD (Conductor Side) – – RF BOARD (Component Side) – Former Type : 1-680-828-11 Former Type : 1-680-829-11 New Type : 1-680-828-12 New Type : 1-680-829-12 – MAIN BOARD (Component Side) – Former Type : 1-680-827-11...
CDX-T67 2. DIAGRAMS 2-1. NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS Note on Printed Wiring Board: Note on Schematic Diagram: • All capacitors are in µF unless otherwise noted. pF: µµF • X : parts extracted from the component side.
CDX-T67 JACK MAIN 3. ELECTRICAL PARTS LIST NOTE: When indicating parts by reference • Due to standardization, replacements in the • Items marked “*” are not stocked since they number, please include the board. parts list may be different from the parts speci- are seldom required for routine service.
Page 52
CDX-T67 MAIN Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark D213 8-719-071-34 DIODE RB521S-30-TE61 R508 1-216-817-11 METAL CHIP 1/16W < IC > R509 1-216-845-11 METAL CHIP 100K 1/16W R510 1-216-845-11 METAL CHIP 100K 1/16W IC201 8-759-829-46 IC BA8272AFV-E2...
Page 53
CDX-T67 Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark < CONNECTOR > CN101 1-793-820-21 CONNECTOR, FPC 22P CN102 1-815-016-21 CONNECTOR, FFC/FPC (ZIF) 16P < IC > IC101 8-752-089-74 IC CXA2581N-T4 IC201 8-759-832-99 IC LA6576L-TE-L < TRANSISTOR >...
Page 55
CDX-T67 CDX-T67 • DIAGRAMS NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS US Model Note on Printed Wiring Board: Note on Schematic Diagram: • All capacitors are in µF unless otherwise noted. pF: µµF • X : parts extracted from the component side.
Page 60
PRINTED WIRING BOARDS – JACK Board – SCHEMATIC DIAGRAM – JACK Board – CN902 CN901 FB901 JACK BOARD FB902 AGND AGND FB903 (COMPONENT SIDE) BUSON BUSON (FOR SONY BUS) DATA DATA B.UP B.UP PS902 B.UP (Page 4) B.UP JACK FLEXIBLE BOARD (CHASSIS)
Page 61
CDX-T67 JACK MAIN • ELECTRICAL PARTS LIST NOTE: When indicating parts by reference • Due to standardization, replacements in the • Items marked “*” are not stocked since they number, please include the board. parts list may be different from the parts speci- are seldom required for routine service.
Page 62
CDX-T67 MAIN Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark D213 8-719-071-34 DIODE RB521S-30-TE61 R508 1-216-817-11 METAL CHIP 1/16W < IC > R509 1-216-845-11 METAL CHIP 100K 1/16W R510 1-216-845-11 METAL CHIP 100K 1/16W IC201 8-759-829-46 IC BA8272AFV-E2...
CDX-T67 REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper right on the revised page allows you to jump to the next revised page. Ver. Date Description of Revision 2001.03...