Lenovo ThinkCentre Edge Hardware Maintenance Manual page 103

Figure 16. Removing the hard disk drive
6. Remove the four screws on the hard disk drive bracket, then remove the hard disk drive out of the
bracket. Do not touch the circuit board on the bottom of the hard disk drive.
Figure 17. Removing the hard disk drive out of the bracket
7. To install the new hard disk drive into the bracket, position the hard disk drive so that the four screw
holes align with those in the bracket.
8. Install the four screws that secure the hard disk drive to the hard disk drive bracket.
9. Connect the hard disk drive cable.
10. Slide the new hard disk drive with the bracket into the hard disk drive bay. Align the screw hole in the
hard disk drive with that in the chassis.
11. Install the screw to secure the hard disk drive bracket to the chassis.
12. Go to "Completing the parts replacement" on page 125.
.
Chapter 8 Replacing FRUs
97