Remote Control
Battery
Door
Phillips
Head
Screw
To access the battery compartment, remove
the small Phillips head screw that secures the
battery door to the transmitter assembly. Install
one (1) 3-Volt, CR2032 battery (included) into the
transmitter. Clean the battery contacts and also those
of the device prior to battery installation. The battery
should be installed with the positive (+) side up.
Please contact your local battery recycling center for
proper battery disposal information.
This product contains a button battery. If swallowed,
it could cause severe injury or death in just two hours.
Seek medical attention immediately.
If you are installing multiple remote-controlled fans on
the same circuit breaker, you may need to perform a few
extra steps to prevent interference or faulty operation of
your remote controls.
Go to www.HunterFan.com/FAQs and click
"How do I properly install multiple remote-controlled fans?"
for more information.
CAUTION:
• Always purchase the correct
size and grade of battery most
suitable for the intended use.
• Replace all batteries of a set at
the same time.
• Clean the battery contacts and
also those of the device prior to
battery installation.
• Ensure the batteries are
installed correctly with regard to
polarity (+ and -).
• Remove batteries from equipment
which is not to be used for an
extended period of time.
• Remove used batteries promptly.
16
16
M3543-01 • 11/25/13 • © Hunter Fan Company
www.HunterFan.com
Note: The remote must be paired before the
Within 3 minutes of restoring power to the
ON
fan, press both the Fan Off button and the High
button for at least 4 seconds. Your fan will turn on
low to indicate successful syncing. If it does not,
turn off power to your fan, wait 1 minute then try
again. If using the transmitter with multiple fans,
repeat this process for each fan.
1.888.830.1326
Fan Off
High
fan will operate.