LG 50PS80 Training Manual page 80

Z - SUS PWB Comparing to Y - SUS During Reset
Z - SUS PWB Comparing to Y - SUS During Reset
PURPOSE: To show the timing between Y-SUS and Z-SUS
From the Waveform it can be seen that the timing of the Z-SUS must align to the Y-SUS for the panel to work
correctly.
If the timing is out of sync, the Control board is at fault.
Note: While making adjustments to the Ramp Up and/or Rame Down portion of the Y-Drive signal, the Control
board makes the same adjustments to the Z-SUS waveform.
August 2009 Plasma 50PS80
80