Cleaning Upholstery; If You Have A Problem; Lubrication; Storage - Hoover Deep Cleaner Owner's Manual

Cleaning upholstery and
automobile interiors
Read "Before you begin cleaning" instructions on page 7.
Be sure to check the cleaning code on your upholstery. Use
your deep cleaner only on upholstery marked "W" or "W/S".
Attach hose and solution tube as instructed on pages 9 and 10.
Fill clean solution tank according to instructions on pages 5 -6.
Use 5 ounces of HOOVER Carpet/Upholstery Detergent.
Dry hands and plug deep cleaner into a properly grounded
outlet.
Turn deep cleaner ON.
Gently press the nozzle onto the fabric. Press the solution
trigger and slowly pull the nozzle over the fabric.
Overlap strokes by one-half inch to help prevent streaking.
Make additional strokes without pressing the trigger to remove
more moisture.
To clean in corners or creases, lift the nozzle one-half inch from
the fabric and press the solution trigger. Vacuum up the solution
with the nozzle without pressing the trigger.
For heavily soiled areas, it may be necessary to repeat the
cleaning process. Make crisscrossing strokes to the original
pattern; overlap each pass.
Make no more than 2 passes with the solution over any one
area to prevent overwetting and damage to fabric.
If additional cleaning is necessary, wait until the upholstery is
completely dry before using the nozzle again.
When finished cleaning, follow "After cleaning" instructions on
page 8 and "After using stair/upholstery nozzle" instructions on
pages 10-11.

Lubrication

The motor is equipped with bearings which contain sufficient
lubrication for the life of the motor. The addition of lubricant
could cause damage. Do not add lubricant to motor
bearings.
HOOVER and
THE HOOVER COMPANY, NORTH CANTON, OHIO 44720
R2 8-98 F5821
12
are registered trademarks

Storage

Before storing:
• Empty solution tank and rinse thoroughly with clean
water.
• Replace empty solution tank and turn deep cleaner
ON. Squeeze trigger and push deep cleaner forward
and back several times to expel any solution
remaining in the deep cleaner's system. (Do not use
deep cleaner on wood floors.)
• Empty recovery tank and rinse thoroughly with clean
water
Allow underside of deep cleaner to air dry thoroughly
before storing deep cleaner on a carpeted or wood
surface.
Do not store deep cleaner with a full solution tank in
place.

If you have a problem

If a minor problem occurs, it usually can be solved quite easily
when the cause is found by using the check list below.
Problem: Machine won't run
Possible cause
Possible solution
• Not firmly plugged in
• Plug unit in firmly
• No voltage in wall plug
• Check fuse or breaker
• Blown fuse/tripped breaker
• Replace fuse/reset breaker
Problem: Low suction
Possible cause
Possible solution
• Recovery tank lid not on correctly
• Make sure lid is on securely
• Recovery tank full/automatic shut off engaged
• Remove and empty recovery tank
• Obstruction in hose on stair/upholstery nozzle
• Remove hose; clear obstruction
• Recovery tank front panel not replaced after stair or
upholstery cleaning
• Replace recovery tank front panel
Problem: Clean solution won't dispense
Possible cause
Possible solution
• Solution tank not firmly in place
• Make sure tank is securely locked in position
• Solution tank empty
• Refill tank according to instructions for surface being cleaned
• Recovery tank lid not on correctly
• Make sure lid is firmly in place
• Stair/upholstery solution tube not securely fastened
• Make sure tube is securely fastened at connection of hood
Problem: Solution tube on stair/upholstery nozzle won't
connect
Possible cause
Possible solution
• Connector collar pushed forward
• Extend black tabs on connector by pulling collar towards tube
Litho USA 56518-099