JVC AV-48WP55/H Service Manual And Parts List page 15

3.1.8 REAR PANEL
(1) Remove 3 screws [ L ].
(2) Remove 4 screws [ M ].
(3) Take out the REAR PANEL.
NOTE :
• Before the rear panel is inserted into the cabinet, release the
short-circuit between the [SB] connector (1) pin and (2) pin
of the DIGITAL INPUT UNIT. (Refer to "CAUTION AT
DISASSEMBLY" on Page 13).
• After releasing the
connectors, do not turn the power on until the rear panel is
inserted into the cabinet.
• Prior to starting the work, be sure to read the following
written instructions on the CAUTION LABEL attached to the
REAR PANEL.
Prior to starting the work, be sure to read the following
written instructions on the CAUTION LABEL attached to
the REAR PANEL.
UNPLUG THE POWER CORD FROM AC OUTLET BEFORE
OPEN THE REAR COVER (PANEL).
When the rear cover (panel) is removed, follow "CAUTION AT
DISASSEMBLY" procedure in the service manual before
plugging the TV's power cord into an AC outlet.
Failure to follow the procedure will result in PERMANENT
damage to some of the television features.
3.1.9 PARTITION
• Take out the REAR PANEL.
(1) Pull out the PARTITION backward.
3.1.10 REAR COVER
• Take out the SPEAKER GRILLE.
• Take out the FRONT CONTROL BOX.
• Take out the SCREEN ASS'Y.
(1) Remove 2 screws [ N ].
(2) Take out the REAR COVER BRACKET.
(3) Remove 2 screws [ O ].
(4) Remove 2 screws [ P ] from front side.
(5) Slightly pull for backside to disengage of the REAR COVER
from hooks.
(6) Take out the REAR COVER.
NOTE :
• Because of the large size, at least two persons are
recommended for removal and reassemble.
short-circuit between the
PARTITION
[SB]
M
L
P
O
HOOK
N
REAR COVER
BRACKET
REAR PANEL
Fig.5
REAR COVER
BRACKET
P
Fig.6
(No.YA097)1-15