Transmitter Part; Only For Training And Service Purposes - LG KC780 Service Manual

domain is performed by low/high band quadrature direct down conversion mixers. The baseband chain contains
a LNB (low noise buffer), channel filter, output buffer and DC-offset compensation. The 3rd order low pass filter
is fully integrated and provides sufficient suppression of blocking signals as well as adjacent channel interferers
and avoids anti-aliasing through the baseband ADC. The receive path is fully differential to suppress on-chip
interferences. Several gain steps are implemented to cope with the dynamic range of the input signals.
Depending on the baseband ADC dynamic range, single- or multiple gain step switching schemes are
applicable. Furthermore an automatic DC-offset compensation can be used (depending on the gain setting) to
reduce the DC-offset at baseband-output. A programmable gain correction can be applied to correct for front
end- and receiver gain tolerances.

3.21. Transmitter part

The GMSK transmitter supports power class 4 for GSM850 and GSM900 as well as power class 1 for DCS1800
and PCS1900. The digital transmitter architecture is based on a very low power fractional-N Sigma-Delta
synthesizer without any external components (see Figure39). The analog I/Q modulation data from the
baseband is converted to digital, filtered and transformed to polar coordinates. The phase/frequency signal is
further on processed by the Sigma-Delta modulation loop. The output of its associated VCO is divided by four or
two, respectively, and connected via an output buffer to the appropriate single ended output pin. This
configuration ensures minimum noise level. The 8PSK transmitter supports power class E2 for GSM850 and
GSM900 as well as for DCS1800 and PCS1900. The digital transmitter architecture is based on a polar
modulation architecture, where the analog modulation data (rectangular I/Q coordinates) is converted to digital
data stream and is subsequently transformed to polar coordinates by means of a CORDIC algorithm. The
resulting amplitude information is fed into a digital multiplier for power ramping and level control. The ready
processed amplitude signal is applied to a DAC followed by a low pass filter which reconstructs the analog
amplitude information. The phase signal from the CORDIC is applied to the Sigma-Delta fractional-N
modulation loop. The divided output of its associated VCO is fed to a highly linear amplitude modulator,
recombining amplitude and phase information. The output of the amplitude modulator is connected to a single
ended output RF PGA for digitally setting the wanted transmit power. The PA interface of SMARTi-PM supports
direct control of standard dual mode power amplifiers (PA's) which usually have a power control input VAPC
and an optional bias control pin VBIAS for efficiency enhancement. In GMSK mode, the PA is in saturated high
efficiency mode and is controlled via its VAPC pin directly by the baseband ramping DAC. In this way both up- /
down-ramping and output power level are set. In 8PSK mode, the ramping functionality is assured by an
on-chip ramping generator, whereas output power is controlled by the PGA's as described above.
Copyright © 2008 LG Electronics. Inc. All right reserved.

Only for training and service purposes

Figure 35. Transmitter Architecture Block Diagram
- 63 -
3. TECHNICAL BRIEF
LGE Internal Use Only