A local telephone company may make changes in its communications facilities or procedure. If these changes could reasonably be expected to affect the use of the KC780 or compatibility with the network, the telephone company is required to give advanced written notice to the user, allowing the user to take appropriate steps to maintain telephone service.
1. INTRODUCTION 1.2.4. Maintenance Limitations Maintenance limitations on the KC780 must be performed only at the LGE or its authorized agents. The user may not make any changes and/or repairs expect as specifically noted in this manual. Therefore, note that unauthorized alternations or repair may affect the regulatory status of the system and may void any remaining warranty.
3. TECHNICAL BRIEF III-1 Baseband circuit 3.1. KC780 Component Block diagram. KC780 is composed with 5 different PCB part such as main PCB, Key PCB, Key FPCB, LCD FPCB and Flash FPCB The functional component arrangement is mentioned below diagram.
FEM control PAEN PA_EN PAM Power on VRAMP TX_RAMP 3.3.4. USART Interface KC780 have a UART Driver as follow : - USART1 : Hardware Flow Control / SW upgrade / Calibration Table 3 USART Interface Spec. USART_0(USART1) Resource Name Remark...
Remote control key detect 3.3.6. GPIO map Over a hundred allowable resources, KC780 is using as follows except dedicated to SIM and Memory. KC780 GPIO(General Purpose Input/Output) Map, describing application, I/O state, and enable level, is shown in below table.
Figure 10 Remote power on and End-key power on circuit 3.6. SIM interface KC780 supports 1.8V & 3V plug in SIM, SIM interface scheme is shown in (Figure 10). SIM_IO, SIM_CLK, SIM_RST ports are used to communicate with BBP(S-GOLDradio) and the SIM power supply enabled by BBP (_SIM_EN).
_EXTRST Figure 19 JTAG interface connector In case of KC780 mass production, the JTAG interface connector will not be mount on board. That is only for developing and software debugging purpose.( It will not be mounted on mass production PCB)
3. TECHNICAL BRIEF 3.13. Audio KC780 Audio signal flow diagram as following diagram. Figure 20 Audio signal flow diagram 3.13.1. Audio amplifier sub system IC with Codec The WM8990 is an ultra-low power hi-fi Codec designed for multimedia handsets. A powerful 1W speaker driver can operate in class D or AB modes, providing total flexibility to the system designer.