Kenmore 592-49032 Use & Care Manual page 27

BEFORE CALLING FOR SERVICE (CONT.)
Water temperature control problem.
(Heater Control problem)
Your Washer has tried to fill but has not reached
the proper water level.
The door will not unlock.
Your washer is not draining.
It can also mean that the unit senses a small
clog while draining.
Your Washer has tried to fill but was
unsuccessful.
Check if the hot water supply hose is
connected.
The hot/cold water hose connection is not
correct.
Electric service was lost when Washer was
running.
A fault is detected in the water level sensor.
Jammed Key.
Motor speed sensor problem.
Temperature sensor problem.
High current detected.
High/Low voltage detected.
592-49032-02855B-01_EN_v1.indd 27
TROUBLESHOOTING GUIDE
Call for service.
Call for service.
Make sure the door is firmly closed.
Push the Power button to turn off your Washer, then turn it on
again. If the code reappears, call for service.
Before calling for service, check the following.
1. Turn off the unit and turn it on again.
2. Select only the Spin Cycle.
3. Press the Start/Pause to drain the water.
4. Clean the debris filter.
If it still does not drain, call for service.
Make sure the water faucets are open all the way. Check for
kinked hoses.
Check the inlet screens on the fill hoses.
You must connect the hot water supply hose because hot water
is supplied by the Auto Temperature Control (A.T.C.) function if
the temperature of the cold water is lower than 59°F.
Please connect the hot/cold water hose connection correctly.
Restart the cycle by pressing the Start/Pause Button.
Call for service
Call for service
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
Motor not running properly.
Restart the cycle.
Call an electrician to check for electrical issues within the home
before calling service.
If the code reappears, call for service.
27
2011-07-22 11:42:19