Omega Montage Elite Massage User Manual page 16

Massage Chair Set Up & Preparation
Backrest Pad Installation
The backrest pad is attached to the backrest with the zipper (View A).
A. Connect the back heating connectors Plug 1 to Plug 2.
B. One connector is located on the inside of the backrest pad and the other is located towards the top of the backrest.
Head Pillow Installation
1. Attach the headrest to the backrest pad by attaching it to the velcro strips. (View B)
2. Attach the head pillow to the headrest by attaching it to the velcro strips.
3. You can adjust the height of the head pillow by attaching it higher or lower to the velcro strips on the headrest.
View A
Adjusting the Intensity of the Back Massage
• You can adjust the intensity of the back massage by adding or removing pads. If the massage is too strong you can add additional pads, a towel or
blanket. One sponge pad is provided for you to place it into the backrest pad to help absorb some of the roller stimulation. If the massage is not
strong enough, then remove the pad. You can flip the backrest pad behind the massage chair (View C) for an intense massage.
• Please keep in mind, you should use your massage chair on a daily basis. However, please gauge your sensitivity to massages prior to using your
massage chair without the backrest pad.
O
Prolonged exposure to heat on the same spot for a long
duration is not recommended.
CAUTION
ViewB
Zipper
ViewC
Velcro Strips
Head Pillow
Sponge Pad