Reset Function; Troubleshooting - Sony TRINITRON KV-DR29M61 Service Manual

x

Troubleshooting

If you have any problem while viewing your TV, you can either use the Reset
function or check the Troubleshooting guide below. If the problem persists,
contact your Sony dealer.
RESET
RESET
TV
Troubleshooting guide
Symptom
• The connection is loose
Snowy picture
or the cable is
damaged.
• The antenna setup is
inappropriate.
• Channel presetting is
Noisy sound
inappropriate or
incomplete.
• Signal transmission is
low.
• Broadcast signals are
Distorted picture
too strong.
Noisy sound
• The TV system setting
Good picture
is inappropriate.
• PIP sound is selected
when PIP is displayed.
(KV-DR34M69/
DR29M69 only)
Noisy sound

Reset function

Press the RESET button on your remote control.
Your TV will go blank for about half a second
then the picture will reappear with "RESET"
displayed on your TV screen for about 10 seconds.
Pressing RESET will set your TV to the factory
setting, but certain problems may be solved.
Possible cause
• Check the antenna cable and connection
• Check the antenna setup.
• Display the "CH PRESET" menu and
• Try using a booster.
• Display the "CH PRESET" menu and
• Turn off or disconnect the booster if it is in
• Display the "CH PRESET" menu and
• Press SOUND or
Solutions
on the TV, VCR and at the wall.
Contact a Sony dealer for advice.
select "MANUAL PROGRAM" to preset
the channel again.
select "MANUAL PROGRAM".
Then, select " SENS: LOW".
(KV-DR34M69/DR29M69 only)
use.
select the appropriate TV system
("TV SYS").
.
Page
31
–
29
–
30
–
29
13
continue
Additional Information
33