PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE • Never reuse a disconnected chip component. THESE COMPONENTS WITH SONY PARTS WHOSE PART NUM- • Notice that the minus side of a tantalum capacitor may be dam- BERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLE- aged by heat.
STR-LV500 SECTION 1 GENERAL This section is extracted from instruction manual. List of button locations and reference pages Main unit ALPHABETICAL ORDER Display 2 INPUT SELECTOR 3 MUTING 6 PHONES jack 8 PRESET TUNING +/– 4 SOUND FIELD 7 VOLUME 5...
STR-LV500 SECTION 2 SERVICIN NOTE SERVICE POSITION • POWER BOARD 1 Remove five screws (+BVTP 3x8) Power board Isolation sheet...
Page 5
STR-LV500 • DIGITAL, DIG-IN, VIDEO BOARD 4 Video board 2 Tuner unit 6 Dig-In board 5 Five screws (+BVTP 3x8) 3 Three screws (+BVTP 3x8) 7 Three screws (+BVTP 3x8) 1 Three screws (+BVTP 3x8) 9 Digital board 8 Four screws...
Page 6
STR-LV500 • AMP BOARD • On Removal 1 Bend claws 90 degree counterclokwise. 2 Slide down the heat sink. • On Attaching 2 Bend claws 90 degree AMP board clokwise. 1 Slide up the heat sink. Heat sink.
STR-LV500 Ver 1.1 SECTION 3 TEST MODE SOUND FIELD CLEAR MODE KEY CHECK MODE * The preset sound field is cleared when this mode is activated. * Button check Use this mode before returning the product to clients upon * Procedure: completion of repair.
Page 8
STR-LV500 Items Function Description Remark NORM Normal channel output t Front Left, Surround Left, Center channel output Left input Right input t Front Right, Surround Right, Sub Woofer channel output Selection of setting SWAP Left input t Center channel output...
STR-LV500 SECTION 4 DIAGRAMS 4-1. IC Pin Function Descriptions • IC115 CXD9617R (AUDIO DSP) (DIGITAL BOARD) Pin No. Pin Name Description — Ground terminal XRST Rest input from the system control EXTIN Not used (connected to ground) Not used (connected to ground) VDD1 —...
Page 10
STR-LV500 Pin No. Pin Name Description PAGE0 Not used (open) BOOT Not used (connected to ground) BTACT Not used (open) Boot strap signal input from MB90478 MOD1 Mode input (connected to VDD) MOD0 Mode input (connected to ground) EXLOCK Lock signal input to LC89056W VDDI —...
Page 11
STR-LV500 • IC118 MB90478PF-G-149-BND (SYSTEM CONTROL) (DIGITAL BOARD) Pin No. Pin Name Description DATA O Serial data input from LC89056W External memory data input from CXD9617R Boot strap signal output to CXD9617R Chip selection signal output to CXD9617R HACN Acknowledge signal input from CXD9617R...
Page 12
STR-LV500 Pin No. Pin Name Description Flash programming MD2 input RDS INT RDS clock input to tuner RDS DATA RDS data input to tuner SIRCS Data input from the remote control receiver DIAG Protect POWER KEY Power swich detection signal input...
Page 13
STR-LV500 • Circuit Boards Location AMP board POWER board VIDEO board REG board H. P board DIG-IN board FM/AM tuner DISPLAY board FILTER board DIGITAL board THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS. (In addition to this necessary note is printed in each block.) For schematic diagrams.
STR-LV500 : Uses unleaded solder. PRINTED WIRING BOARDS – DIGITAL SECTION (SIDE B) – • Refer to page 13 for Circuit Boards Location. FILTER BOARD (SIDE B) DIGITAL BOARD FLASH PROGRAMMING HDD/MD TU901 TUNER UNIT TV/SAT DVD IN DISPLAY BOARD...
STR-LV500 4-12. PRINTED WIRING BOARD – DISPLAY SECTION – • See page 13 for Circuit Boards Location. : Uses unleaded solder. VIDEO BOARD VIDEO IN DVD IN TV/SAT IN DIGITAL BOARD BOARD (Page 25) (Page 17) H.P BOARD MONITOR OUT...
STR-LV500 SECTION 5 EXPLODED VIEWS NOTE: • -XX, -X mean standardized parts, so they may • The mechanical parts with no reference number The components identified by mark 0 or have some differences from the original one. in the exploded views are not supplied.
STR-LV500 5-2. CABINET SECTION T901 TU901 supplied The components identified by mark 0 or dotted line with mark 0 are critical for safety. Replace only with part number specified. Ref. No. Part No. Description Remark Ref. No. Part No. Description...
STR-LV500 SECTION 5 ELECTRICAL PARTS LIST NOTE: • SEMICONDUCTORS • Due to standardization, replacements in the • CAPACITORS: In each case, u: µ, for example: parts list may be different from the parts uF: µF uA...: µA... , uPA... , µPA... , specified in the diagrams or the components •...
Page 44
STR-LV500 REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper right on the revised page allows you to jump to the next revised page. Ver. Date Description of Revision 2003.06...