Honeywell TRADELINE T7200D Installation Instructions Manual page 7

NOTE: If a duct temperature sensor is installed, the duct
temperature is also displayed.
Refer to Table 4 and Thermostat Information section for
directions and results of the specific system tests.
NOTE: Press Run Program to exit the system test. The
system test times out after four minutes if there
are no additional key presses.
Set Program Start Time Set Day/Time Set Day/Time
Em Ht Em Ht
Aux Ht
Comm
Mon
TueWedThuFriSatSun
Un Occupied 12 Override
System
Em Heat Off Cool Auto
Fig. 10. LCD display of all segments.
Key to Press
Heating Equipment Test
Heat/Cool Settings
Cooling Equipment Test
Heat/Cool Settings
Fan Equipment Test
Heat/Cool Settings
Key Operation Test
Heat/Cool Settings
Unoccupied Temp
Occupied Temp
Clear Start Time
Day
Copy
Unoccupied Start
TIme
System
(select models)
Fan (select models)
Set Current Day/Time
Run Program
Temporary Occupied
Occupied Start Time
Continuous
Unoccupied
T7200D,E SERIES 2000 COMMERCIAL MICROELECTRONIC THERMOSTATS
Temporary Setting Enrg
AM
Room
PM
%Humid
Heat Cool Remote
In Recovery Auto Only
Lo Med Fan
Hi
Wait On
Table 4. Installer System Test Options.
Test
Number
10 Enter heating equipment test.
11 Heat turns on. The system fan is also energized.
10 Heat and system fan turn off.
30 Change from heating to cooling equipment test.
31 Cool and system fan turn on.
30 Cool and system fan turn off.
40 Change from cooling to fan equipment test.
41 Fan turns on.
40 Fan turns off.
60 2 Change from fan to key operation test.
60 0 Unoccupied Temp test number is displayed.
60 1 Occupied Temp test number is displayed.
60 3 Increase test number is displayed.
60 5 Decrease test number is displayed.
60 7 Clear Start Time test number is displayed.
60 8 Day test number is displayed.
60 9 Copy test number is displayed.
60 10 Unoccupied Start Time test number is displayed.
60 11 System test number is displayed.
60 12 Fan test number is displayed.
60 14 Set Current Day/Time test number is displayed.
60 15 Run Program test number is displayed.
60 16 Temporary Occupied test number is displayed.
60 17 Occupied Start Time test number is displayed.
60 19 Continuous Unoccupied test number is displayed.
Sav
Duct
Auto
M4916
Description
7
TEST NUMBER
Fig. 11. Test number display.
M10257A
62-0128—2