Panasonic WR-DA7 Service Manual page 9

Channel Fader Strip
1
Channel numbers
AUX/BUS Layer
function
Channel Fader Strip
There are sixteen Channel Fader Strips on the DA7 .
Depending on the selection of the four Fader Layer
controls, each strip directly controls (1) INPUT 1-16, (2)
INPUT 17-32, (3) AUX/BUS (indicated on the bottom of the
strip), and (4) a user CUSTOM/MIDI function.
The MIC/LINE INPUT knob varies the channel input gain
volume and adjusts for either a mic or line-level input. Due to
the high quality design of this circuit, there is no pad switch
necessary; the input knob range sets the input level. This
knob only affects the analog inputs 1-16.
The PEAK/SIGNAL LED indicates when an input signal is
present ( green ), and when the input signal level is too high
( red ).
The LED field indicators reflect the auxiliary (AUX) routing
assignments and automation parameters. The LED color
signifies the AUTOMATION/AUX button selection; AUX
( green ), AUTOMATION ( red ).
The SOLO LED button toggles on ( red ) or off. When on, the
channel output will be routed to the MONITOR A speakers
(overriding the MONITOR A input), and to the headphones.
The FLIP LED button flips the control of the Channel Fader
Strip from one input layer to the other. The LED color
indicates the current input selection and matches the Fader
Layer control LED button colors, INPUTS 1-16 ( green ) or
INPUTS 17-32 ( red ).
The SELECT LED button, when on ( orange ), identifies the
channel as the current channel selected. Only one Fader
Strip can be selected at a time (unless it's in stereo or link
mode).
MIC/LINE INPUT knob
PEAK/SIGNAL LED
LED field indicators for AUX 1-6,
and automation parameters, CH,
EQ, PANASSIGN/SURR, LIBRARY
and SEL/MAN
SOLO LED button
FLIP LED button
SELECT LED button
On LED button
Fader
For more detail, see Chapter 5, Channel, Library, and
Meter Windows in the Users' Guide.
The ON LED button toggles on ( red ) and off. When on, the
channel output is active.
There are two channel numbers for each strip, indicating the
INPUT connections on the Rear Panel of the DA7 .
The AUX/BUS label at the bottom of a Channel Fader Strip
indicates its function when the AUX/BUS Fader Layer
control is selected.
See Chapter 6, Fader Layers and Channel Strips in the
Users' Guide for additional information.
AUTOMATION/AUX LED Button
2
AUTOMATION/AUX LED Button
The AUTOMATION/AUX LED button toggles the display of
the Channel Fader Strips LED field indicators. The LED
color indicates the current selection.
See Chapter 14, Automation and Chapter 10, AUX in the
Users' Guide for additional information.
MASTER DISPLAY Section
3
METER button
CHANNEL button
MASTER DISPLAY Section
Pressing the METER button will display the [METER]
window group on the LCD screen in the Display Bridge.
Pressing the METER button again will cycle the three
window selections: [METER INPUTS 1-32], [BUS/AUX],
[SLOT].
Pressing the CHANNEL button will display the [CHANNEL]
window group on the LCD screen in the Display Bridge.
The window displayed will show the current mixer strip
selected.
See Chapter 5, Channel, Library, and Meter Windows in
the Users' Guide for additional information.
2