1-9. G3 BOARD (POWER UNIT) AND D1 BOARD REMOVAL
(KDL-40S3000/46S3000 ONLY)
1
Disconnect 6 connectors
2
Remove 4 screws, +PSW 3SG
3
Disconnect 4 connectors
4
Remove 4 screws, +PSW 3SG
1-9-1. REPLACING THE INVERTER CONNECTOR ASSEMBLY (KDL-40S3000/46S3000 ONLY)
Use the following procedure to confirm that the Inverter connector is securely attached
to the board.
1
After inserting the connector
into the board, push the
middle section of the inverter
connector to confirm it
is securely connected.
KDL-26S3000/32S3000/40S3000/46S3000
4
D1 Board
3
2
Push the right section of
the inverter connector and
confirm it is securely
connected.
KDL-26S3000/32S3000/40S3000/46S3000
1
3
Push the left section of
the inverter connector and
confirm it is securely
connected.
2
G3 Board
G3 Bracket
16