Setting Up Your Tv ("Initial Setup") - Sony TRINITRON KV-HW21M80 Service Manual

x Setting up your TV
("Initial Setup")
When you turn on your TV for the first time, the "Initial Setup" menu will appear.
You may change the menu language, preset the TV channels automatically and adjust
the picture position using the buttons on the top control panel.
Tip
and V/v/B/b buttons on the remote control can also be used for the
• The MENU,
operations below.
1
Press 2 +/– to select the desired menu
language, then press t.
The selected menu language appears.
2
Press 2 +/– to select "Yes", then press t
to preset the channels automatically or
select "No" to skip automatic channel
presetting.
Once you select "Yes", your TV will start
searching for all the available channels.
If the message "No channel found. Please
connect cable/antenna." appears, check your
TV connections, then press t.
3
Press 2 +/– to adjust the bars on the
top and bottom of the menu if they are
slanted, then press t (KV-HW21M85/
HW21M81 only).
If no adjustment is necessary, then press
t.
4
Press 2 +/– to select "No", then press t.
This menu will not appear again the next
time you turn on the TV by pressing !.
To allow this menu to appear again, select
"Yes", then press t.
Tips
• You can immediately go to the end of the "Initial Setup" menu by pressing MENU.
• You can also set up your TV by pressing the MENU button on the top control panel for about
five seconds or using the menu system (see page 13).
7
Installation