AA-2W SERVICE MANUAL CHASSIS MODEL NAME REMOTE COMMANDER DESTINATION CHASSIS NO. KV-29FV16A RM-Y171 Argentina SCC-S34P-A RM-Y171 KV-29FV16A TRINITRON COLOR TELEVISION ® 9-965-908-01...
AV Cable: VMC-810/820/830 HG • Audio Cable: RKC-515HG The ( ) SRS (SOUND RETRIEVAL SYSTEM) is manufactured by Sony S-LINK Cable: RK-G69HG Corporation under license from SRS Labs, Inc. It is covered by U.S. Component Video Cable: VMC-10/30 HG Patent No. 4,748,669. Other U.S. and foreign patents pending.
Ne les remplacer que par des composants sony dont le numero de piece est indique dans le present manuel ou dans des supplements publies par sony. Les reglages de circuit dont l’importance est critique pour la securite du fonctionnement sont identifi...
KV-29FV16A SAFETY CHECK-OUT Leakage Test After correcting the original service problem, perform the following The AC leakage from any exposed metal part to earth ground and from safety checks before releasing the set to the customer: all exposed metal parts to any exposed metal part having a return to chassis, must not exceed 0.5 mA (500 microamperes).
KV-29FV16A 1-5. PICTURE TUBE REMOVAL WARNING: BEFORE REMOVING THE ANODE CAP High voltage remains in the CRT even after the power is disconnected. To avoid electric shock, discharge CRT before attempting to remove the anode cap. Short between anode and CRT coated earth ground strap.
KV-29FV16A SECTION 2: SET-UP ADJUSTMENTS The following adjustments should be made when a complete Perform the adjustments in order as follows: realignment is required or a new picture tube is installed. Beam Landing These adjustments should be performed with rated power supply Convergence voltage unless otherwise noted.
KV-29FV16A 2-2. CONVERGENGE OPERATION OF BMC (HEXAPOLE) MAGNET Preparation: The respective dot positions resulting from moving each magnet interact, • Perform FOCUS, V. LIN and V. SIZE adjustments. so perform adjustment while tracking. • Set BRIGHTNESS control to minimum. 1 Use the V.STAT tabs to adjust the red, green, and blue dots so they •...
KV-29FV16A 2-3. FOCUS 2-5. WHITE BALANCE ADJUSTMENTS 1. Input monoscope signal. Disp. Item All Models 2. Set user controls to normal. 3. Set video mode to STANDARD. RDRV Red Drive 4. Set the PICTURE to maximum. GDRV Green Drive BDRV Blue Drive 5.
KV-29FV16A SECTION 3: SAFETY RELATED ADJUSTMENTS 3-1. X R530, R531 CONFIRMATION digital METHOD (HOLD-DOWN multimeter CONFIRMATION) AND READJUSTMENTS Always perform the following adjustments when replacing the following TP85 T503 R531 R530 components marked with a Y mark on the schematic diagram:...
KV-29FV16A SECTION 4: CIRCUIT ADJUSTMENTS ELECTRICAL ADJUSTMENTS BY REMOTE COMMANDER Use the Remote Commander (RM-Y171) to perform the circuit adjustments in this section. Test Equipment Required: 1. Pattern generator 2. Frequency counter 3. Digital multimeter 4. Audio oscillator 4-1. SETTING THE SERVICE ADJUSTMENT...
KV-29FV16A 4-4. A BOARD ADJUSTMENTS V. SIZE ADJUSTMENT (VSIZ) SUB BRIGHT ADJUSTMENT 1. Input a monoscope signal. 2. Set to Service Adjustment Mode. 1. Set to Service Adjustment Mode. 3. Select VSIZ with 1 and 4 . 2. Input a grey scale pattern signal.
Page 20
KV-29FV16A V LINEARITY (VLIN), V CORRECTION (VSCO), OSD POSITION ADJUSTMENT (DISP) PIN AMP (PAMP) AND TRAPEZIUM (TRAP) 1. Input a color-bar signal. ADJUSTMENTS 2. Set to Service Adjustment Mode. 3. Select DISP with 1 and 4 . 1. Input a cross-hatch signal.
KV-29FV16A SECTION 5: DIAGRAMS 5-1. CIRCUIT BOARDS LOCATION The components identifi ed by shading and symbol are critical for safety. Replace only with part number specifi ed. HX Board The symbol indicates a fast operating fuse and is displayed on the component side of the board.
KV-29FV16A A BOARD SCHEMATIC DIAGRAM A BOARD: IC 355 CXA2135S — — — — — — — — — — — A BOARD: IC 561 STV9379 — OUTPUT SUPPL Y ST AGE FL YBACK VOL TAGE SUPPL Y GENERA TOR...
Page 26
KV-29FV16A A BOARD WAVEFORMS A BOARD IC VOLTAGE LIST IC001 volt 1.9 Vp-p (H) 4.9 Vp-p (H) 5.6 Vp-p (H) 5.2 Vp-p (V) IC353 volt 3.9 Vp-p (8 MHz) 0.9 Vp-p (H) IC355 IC501 volt volt -3.5 IC002 volt -13.8 1.7 Vp-p (H)
Page 28
KV-29FV16A AK BOARD IC VOLTAGE LIST IC1401 34.5 volt IC1403 volt IC1461 IC1901 volt volt AK BOARD WAVEFORMS IC1402 volt IC1902 volt All voltages are in V 1.9 Vp-p (H) 4.8 Vp-p (H) [AUDIO AMP/TRUSURROUND/2ND-TUNER/S-LINK] AK BOARD LOCATOR LIST —...
KV-29FV16A C BOARD SCHEMATIC DIAGRAM — — — — — C BOARD IC VOLTAGE LIST C BOARD WAVEFORMS IC1701 volt All voltages are in V 139.0 Vp-p (H) 116.2 Vp-p (H) 126.1 Vp-p (H) — 29 —...
Page 37
KV-29FV16A [3D LINE COMB FILTER / AV SW / AUDIO CONTROL / SRS / PIP ENCODE / CHROMA DECODE] CONDUCTOR SIDE COMPONENT SIDE UY BOARD LOCATOR LIST comp cond DIODE Q211 comp cond — D201 Q212 — D202 Q231 D203...
Page 38
KV-29FV16A UY (MAIN) BOARD IC VOLTAGE LIST IC261 IC3504 volt volt IC2006 volt GND GND IC2009 volt IC1051 volt All voltages are in V UY (PIP) BOARD IC VOLTAGE LIST IC3302 IC3308 volt volt GND GND IC3303 volt IC3305 volt...
KV-29FV16A [VELOCITY MOD.] — — — WA BOARD IC VOLTAGE LIST WA BOARD LOCATOR LIST IC961 DIODE Q942 volt D941 Q943 D943 Q944 D944 Q945 D945 Q946 -13.9 D946 Q947 D947 Q948 11.7 IC964 D962 Q949 IC962 volt D963 Q961...
KV-29FV16A SECTION 6: EXPLODED VIEWS Components not identifi ed by a part number or The component parts of an assembly are indicated by Items marked with an asterisk are not stocked since description are not stocked because they are seldom the reference numbers in the far right column of the parts they are seldom required for routine service.
4-031-319-01 SPACER, DY 4-068-985-13 DOOR 4-062-970-12 CLIP (29RSN), DGC 4-068-984-01 MULTI-BUTTON (BOTTOM) 1-452-896-11 COIL, NA ROTATION (RT200) 3-704-179-31 EMBLEM (NO.9), SONY 4-036-329-11 SPRING (B), TENSION 4-068-995-01 BUTTON, MAIN POWER ! 69 1-419-157-11 COIL, DEGAUSSING 4-052-635-01 MAIN POWER BRACKET 1-452-094-00 CIRCULAR DISC MAGNET B...
KV-29FV16A SECTION 7: ELECTRICAL PARTS LIST NOTE: The components identifi ed by shading RESISTORS The components in this manual identifi ed by the following mark are critical for safety. Replace only • All resistors are in ohms symbol: indicate parts that have been carefully factory- with part number specifi...
Page 46
KV-29FV16A NOTE: Les composants identifi es par un trame et une NOTE: The components identifi ed by shading marque sont critiques pour la securite. Ne les mark are critical for safety. Replace only remplacer que par une piece portant le numero specifi e.
Page 47
KV-29FV16A NOTE: Les composants identifi es par un trame et une NOTE: The components identifi ed by shading marque sont critiques pour la securite. Ne les mark are critical for safety. Replace only remplacer que par une piece portant le numero specifi e.
Page 48
KV-29FV16A NOTE: Les composants identifi es par un trame et une NOTE: The components identifi ed by shading marque sont critiques pour la securite. Ne les mark are critical for safety. Replace only remplacer que par une piece portant le numero specifi e.
Page 49
KV-29FV16A NOTE: Les composants identifi es par un trame et une NOTE: The components identifi ed by shading marque sont critiques pour la securite. Ne les mark are critical for safety. Replace only remplacer que par une piece portant le numero specifi e.
Page 50
KV-29FV16A NOTE: Les composants identifi es par un trame et une NOTE: The components identifi ed by shading marque sont critiques pour la securite. Ne les mark are critical for safety. Replace only remplacer que par une piece portant le numero specifi e.
Page 51
KV-29FV16A NOTE: Les composants identifi es par un trame et une NOTE: The components identifi ed by shading marque sont critiques pour la securite. Ne les mark are critical for safety. Replace only remplacer que par une piece portant le numero specifi e.
Page 52
KV-29FV16A NOTE: Les composants identifi es par un trame et une NOTE: The components identifi ed by shading marque sont critiques pour la securite. Ne les mark are critical for safety. Replace only remplacer que par une piece portant le numero specifi e.
Page 53
KV-29FV16A A component identifi ed by this symbol indicates that it NOTE: The components identifi ed by shading has been carefully factory-selected to satisfy regulations mark are critical for safety. Replace only regarding X-ray radiation. Should replacement be required, with part number specifi ed.
Page 54
KV-29FV16A A UY NOTE: Les composants identifi es par un trame et une NOTE: The components identifi ed by shading marque sont critiques pour la securite. Ne les mark are critical for safety. Replace only remplacer que par une piece portant le numero specifi e.
Page 59
KV-29FV16A REF.NO. PART NO. DESCRIPTION VALUES REF.NO. PART NO. DESCRIPTION VALUES R2015 1-216-081-00 RES-CHIP 1/10W R1228 1-208-774-11 METAL CHIP 0.50% 1/10W R1229 1-216-121-11 RES-CHIP 1/10W R2016 1-216-081-00 RES-CHIP 1/10W R1230 1-216-073-00 RES-CHIP 1/10W R2017 1-216-295-11 SHORT R1231 1-216-295-11 SHORT R2018...
Page 60
KV-29FV16A UY GA NOTE: Les composants identifi es par un trame et une NOTE: The components identifi ed by shading marque sont critiques pour la securite. Ne les mark are critical for safety. Replace only remplacer que par une piece portant le numero specifi e.
Page 61
KV-29FV16A NOTE: Les composants identifi es par un trame et une NOTE: The components identifi ed by shading marque sont critiques pour la securite. Ne les mark are critical for safety. Replace only remplacer que par une piece portant le numero specifi e.
Page 62
KV-29FV16A NOTE: Les composants identifi es par un trame et une NOTE: The components identifi ed by shading marque sont critiques pour la securite. Ne les mark are critical for safety. Replace only remplacer que par une piece portant le numero specifi e.
Page 63
KV-29FV16A NOTE: Les composants identifi es par un trame et une NOTE: The components identifi ed by shading marque sont critiques pour la securite. Ne les mark are critical for safety. Replace only remplacer que par une piece portant le numero specifi e.
Page 64
KV-29FV16A GA C HA NOTE: Les composants identifi es par un trame et une NOTE: The components identifi ed by shading marque sont critiques pour la securite. Ne les mark are critical for safety. Replace only remplacer que par une piece portant le numero specifi e.
Page 65
KV-29FV16A HA HB HX NOTE: Les composants identifi es par un trame et une NOTE: The components identifi ed by shading marque sont critiques pour la securite. Ne les mark are critical for safety. Replace only remplacer que par une piece portant le numero specifi e.
Page 67
KV-29FV16A NOTE: Les composants identifi es par un trame et une NOTE: The components identifi ed by shading marque sont critiques pour la securite. Ne les mark are critical for safety. Replace only remplacer que par une piece portant le numero specifi e.
Page 81
A BOARD: IC 561 STV9379 OUTPUT SUPPL Y ST AGE FL YBACK VOL TAGE SUPPL Y GENERA TOR FL YBACK GENERA TOR INVER TING INPUT POWER OUTPUT AMPLIFIER NON-INVER T ING INPUT THERMAL PROTECTION...
PRINTING THE SERVICE MANUAL The PDF of this service manual is not designed to be printed from cover to cover. The pages vary in size, and must therefore be printed in sections based on page dimensions. NON-SCHEMATIC PAGES Data that does NOT INCLUDE schematic diagrams are formatted to 8.5 x 11 inches and can be printed on standard letter-size and/or A4-sized paper. SCHEMATIC DIAGRAMS The schematic diagram pages are provided in two ways, full size and tiled.
Page 87
ON-SCREEN SEARCH OPTION All of the text within the service manual PDF is content searchable. This means that you can enter any text, word, phrase or reference number that appears in the manual, and the PDF software will search, fi nd and move the cursor to the location where you requested text fi rst appears. This feature can be particularly useful in locating components on a specifi...
Need help?
Do you have a question about the TRINITRON KV-29FV16A and is the answer not in the manual?
Questions and answers