Table of Contents
Advertisement
Door removal
Disconnect electrical supply to refrigerator before
installing. Failure to do so could result in death or
serious injury. If your front door is too narrow to get
the refrigerator into the house, remove the refrigerator
doors and pass the appliance through laterally.
Remove the lower cover by loosening all the screws. Then push in the feed water tube
Remove lower
while depressing the connector , as shown in the illustration on the right.
cover and then
feed water tube
•
1) Remove the hinge cover by loosening
Remove the
freezer
compartment
door
2) Remove the keeper by rotating it counter clockwise
•
3) Remove the freezer compartment door by lifting it
•
Remove the
1) Loosen the hinge cover screws and
refrigerator
compartment
door
8
1_MFL67795101_Eng.indd 8
Electric Shock Hazard
Applicable to No Plumbing
Ice & Water Model only
Feed water tube
NOTE
If a tube end is deformed or abraded, trim the end with sharp knife until perfectly round.
the screws. Then separate all
connection wires except for the earth.
( ) and then lifting the upper hinge up ( ).
NOTE
When removing the upper hinge, be careful that
the door does not fall forwards.
upward. The door should be lifted high enough for the
feed water pipe tube to be completely pulled out.
NOTE
If you have removed the refrigerator compartment
door to pass the appliance through an access door, lay
the door down, but be careful not to damage the feed
water pipe tube.
remove the cover. Remove connection
wires, if any, except for the earth line.
Lower cover
Feed water tube
Hinge cover
Upper hinge
Lower hinge
Installation
Connection
wires
Upper hinge
Keeper
Engough for
water feed pipe
tube to be completely
pulled out
Connection
wires
2013.4.15 9:5:49 AM
Advertisement
Table of Contents
