Identifying Drawers; Identifying Drives - Dell PowerVault MD3060e Administrator's Manual

For EMMs:
It is important to take note of the Enclosure Slot Index and the WWN (worldwide name) columns. These
values will be needed for required command parameters.

Identifying Drawers

To verify the status and number of drives in the drawers of an enclosure, execute the following
command:
secli list drawers -a=<(SASAddress | AdapterIndex)> -enc=<(WWN | EnclIndex)>
Output
NOTE: Drawer 0 is the top drawer in the enclosure.

Identifying Drives

When identifying drives, there are additional optional parameters that be can included to narrow the
scope of the drives to obtain information from. Drives can be discovered from the adapter (all down
chain enclosures attached to a specified HBA), all the drives in a specific enclosure, or all the drives in a
specified drawer in a specified enclosure. To get information about all the drives visible to an adapter,
execute the following command:
To get information about all the drives visible to an adapter:
secli list drives -a=<(SASAddress | AdapterIndex)>
Output
For all the drives visible to an adapter:
16