Toshiba SD-P2600 Service Manual page 8

2. Caution in Replacing Parts
Check whether or not the DVD drive, 42-pin FFC and the main board are connected properly after
replacing the DVD drive or the main board. Then, remove the pick protective solder (two points.)
Before replacing the DVD drive or the main board, be sure to solder on the DVD drive to prevent
damage by static electricity.
Solder the harness connecting from the DVD drive on the edge of the main board as the figure shown
below after replacing the DVD drive or the main board. If not, reassembling can not be performed
properly due to interference between parts.
Land for soldering
When replacing PJ705, cut the connector end on the back of the board within 1mm after soldering. If
not, reassembling can not be performed properly due to interference between parts.
Within
1mm
When replacing the label, be sure to fill in the serial number and stick the seal on the label for
protection.
Pick protective solder
The harness connecting
from the DVD drive
Cut the connector end.