Gigaset C610 Manual page 15

Initial charging and discharging of the batteries
The correct charge status can only be displayed if the batteries are first fully
charged and discharged.
¤
Charge the handset in the base for 10 hours.
Please note
The handset must only be placed in the designated Gigaset C610 base or charg-
ing cradle.
¤
After charging, remove the handset from the base and only replace it when the
batteries are fully discharged.
Please note
u
Each handset is registered with the base at the factory. You do not need to
register the handset again. If you wish to use your handset with a different
base or use further handsets with your base, you have to register the handset
¢
manually page 53.
u
After the first battery charge and discharge, you may place your handset in
the base after every call.
u
Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
u
The batteries may warm up during charging. This is not dangerous.
u
After a while, the charge capacity of the batteries will decrease for technical
reasons.
10 h
First steps
13