Table of Contents
Advertisement
NOTE: System switch must be set to Heat or Cool to perform the following:
Temporarily Change Temperature for Current Period Only—
show on display; it will cancel itself at next scheduled change. To cancel sooner, press
Hold a Temperature Indefinitely— ~~~P ,
Check Current Temperature Setting-
pressing this will cancel your change.)
Check Programs— ~~Uk
Cancel a Program- ~~~Ub until program to cancel shows; then H together.
Permanently Change a Program—Repeat steps under Heating Program or Cooling Program
(pages 12 and 13) as applicable.
Return to normal program or start program —
FUEL SWITCH (see illustration on page 17) is
factory-set in the "F position. This is the correct
setting for most systems. If your system is an
e
is facto-~-set for a warm
air, gas or oil heating system. If you are installing
it on another type of system, the system on-time
must be adjusted accordingly by setting screws A
and B on the back of the thermostat. Use the
heating system table shown in the illustration,
(page 17) as a guide. The system on-time should
be optimized according to the type of system to
minimize room temperature swings. Setting the
screw "out one turn" means turning the screw
Temp
0
press pJ& to cancel.
14
-
-
(If using Temporarily Change or Hold,
repeatedly to see each time and temperature; then Program .
u
electric heat system, set the switch to "E. The
"E setting will allow the fan to turn on immedi-
where the "G" terminal is connected.
approximately 360° counterclockwise, or about
one complete turn.
In the unlikely event that you want longer furnace
on-time, readjust screws A and/or B as follows:
First, turn both screws in completely, then adjust
for system type:
Warm Air Furnace-Set at the Hot Water
setting, (A - out one turn, B - in).
Electric Furnace-Leave at the Warm Air
Furnace setting (A - in, B - in).
16
Temp
—
u
. Temporary indicator will
.
-
Run
Time
(
Beck
Customer Assistance
Hide quick links:
Advertisement
Table of Contents
