Honeywell THE DIGITAL ROUND CT8775A Owner's Manual page 6

Mount Decorator Cover Plate (Optional) and Wallplate Directly to Wall
If using the decorator cover plate, pull the wires through
the wiring hole on the decorator cover plate. Position the
decorator cover plate against the wall so that the UP
indicator in the middle of the decorator cover plate is
pointing up.
Position the wallplate:
If using the decorator cover plate, pull the wires
through the wiring hole on the wallplate and place
the wallplate over the decorator cover plate. Turn
the wallplate until the wiring holes are aligned and
the two screw holes on the left and right side of the
wallplate line up with the screw holes on the
decorator cover plate. You will be inserting the
screws through these holes into the wall.
If attaching the wallplate directly to the wall, pull the
wires through the wiring hole on the wallplate and
position it so that the UP indicator on the wallplate is
pointing up.
Use a pencil to mark the center of the screw holes on the
left and right sides of the wallplate.
Remove the wallplate and decorator cover plate (if used)
and drill two 3/16 in. holes in the wall (if drywall) at the
locations you marked. For materials such as plaster, drill
7/32 in. holes where marked. Gently tap the provided
anchors into the drilled holes until they are flush with the
wall.
Pull the wires through the wiring holes and reposition the
decorator cover plate (if used) and wallplate over the
screw holes.
Attach the decorator cover plate (if used) and wallplate to
the wall with two 1-in. screws.
69-1676—1
DECORATOR COVER PLATE
WALL PLATE
1 INCH
SCREW (2)
WIRING HOLES
Fig. 1. Mount decorator cover plate (optional) and
wallplate directly to wall (heating-cooling wallplate
6
WALL ANCHORS (2)
shown).
M19493