Steam, Gravity
High Efficiency Warm Air (90%+ efficiency), Hot Water, Heat Pump 3
Gas or Oil Warm Air (factory setting)
Electric Warm Air
In Floor Radiant Heat
NOTE:
The cooling cycle rate does not require adjustment and therefore cannot be changed.
Fahrenheit/Celsius Indication
Use DIP switch 3 to set the desired temperature indication. See Table 4.
Fahrenheit/Celsius Display
Fahrenheit (factory setting)
STEP 9. MOUNT THE THERMOSTAT
Table 3. Heat Cycle Rate.
Heating System
Table 4. Temperature Indication.
Celsius
ENGAGE TABS
AT BOTTOM OF
THERMOSTAT
AND WALL PLATE.
PRESS UPPER
EDGE OF CASE
TO LATCH
Cycles Per Hour DIP Switch 1 DIP Switch 2
1
6
9
Check with manufacturer for recommended
cycle rate.
M19498
11
On
On
Off
On
Off
Off
On
Off
DIP Switch 3
Off
On
69-1676—1