Asus B85M-D Plus User Manual page 22

Audio 2.1, 4.1, 5.1, or 7.1-channel configuration
Port
Light Blue (Rear panel)
Lime (Rear panel)
Pink (Rear panel)
Lime (Front panel)
To configure a 7.1-channel audio output:
7. USB 2.0 ports 3 and 4. These two 4-pin Universal Serial Bus (USB) ports are for USB
2.0/1.1 devices.
8. USB 3.0 ports 5 and 6. These two 9-pin Universal Serial Bus (USB) ports are for USB
3.0 devices.
•
•
•
•
•
9. Video Graphics Adapter (VGA) port. This 15-pin port is for a VGA monitor or other
VGA-compatible devices.
10. DVI-D port. This port is for any DVI-D compatible device. DVI-D can't be converted to
output RGB Signal to CRT and is not compatible with DVI-I.
11. USB 2.0 ports 9 and 10. These two 4-pin Universal Serial Bus (USB) ports are for
USB 2.0/1.1 devices.
1-14
Headset
2.1-channel
Line In Rear Speaker Out
Line Out Front Speaker Out
Mic In
-
Use a chassis with HD audio module in the front panel to support a 7.1-channel audio
output.
Due to USB 3.0 controller limitations, USB 3.0 devices can only be used under a
Windows OS environment and after USB 3.0 driver installation.
®
The plugged USB 3.0 device may run on xHCI or EHCI mode, depending on the
operating system's setting.
USB 3.0 devices can only be used for data storage.
We strongly recommend that you connect USB 3.0 devices to USB 3.0 ports for faster
and better performance from your USB 3.0 devices.
Due to the design of the Intel
USB 2.0 and USB 3.0 ports are controlled by the xHCI controller. Some legacy USB
devices must update their firmware for better compatibility.
4.1-channel 5.1-channel
Rear Speaker Out
Front Speaker Out
Mic In Bass/Center
-
8 series chipset, all USB devices connected to the
®
Chapter 1: Product introduction
7.1-channel
Rear Speaker Out
Front Speaker Out
Bass/Center
- Side Speaker Out