Using Multiple Handsets; Registering Handsets - Gigaset SL400 User Manual

Melody:
Select melody.
§Save§
Press the display key.
¼
In idle state, the icon and wake-up time
are displayed.
A wake-up call is signalled on the display
and with the selected ringtone (
The wake-up call sounds for 60 seconds. If
no key is pressed, the wake-up call is
repeated twice at five minute intervals and
then switched off.
During a call, the wake-up call is only sig-
nalled by a short tone.
Deactivating the wake-up call/
repeating after a pause (snooze
mode)
Prerequisite: A wake-up call is sounding.
§OFF§
Press the display key. The wake-
up call is deactivated.
Or
§Snooze§
Press the display key or any key.
° is shown in the display. The
wake-up call is deactivated and
then repeated after 5 minutes.
After the second repetition the
wake-up call is deactivated
completely.

Using multiple handsets

Registering handsets

You can register up to six handsets to your
¢
base.
page 3).
A Gigaset handset can be registered on up to
four bases.
Manually registering
Gigaset handsets to the Gigaset
SL400
You must manually register the handset on
both the handset (1) and the base (2).
Once the registration process has been com-
pleted successfully, the handset returns to
idle state. The handset's internal number is
shown in the display e.g., INT 1. If not, repeat
the procedure.
1) On the handset
The handset is not registered to a base.
§Register§
The handset is already registered to a base:
v
¢
If the handset is already registered to four
bases:
s
~
A message appears stating that the hand-
set is searching for a base that is ready for
registration.
2) On the base
¤
Using multiple handsets
Press the display key.
Ï
¢ ¢
Registration
Register Handset
Select base, e.g., Base 3 and
§OK§
press .
If required, enter the system
PIN for the base and press
Within 60 seconds, press and hold the
registration/paging button on the base
¢
( page 2) (approx. 3 seconds).
§OK§
.
57