Epson Aculaser C4000 Setup Manual page 28

You can purchase DIMMs from various vendors. Be sure they
meet the following requirements:
DRAM type
Memory size
CAS Latency
Type
Height
* SPD stands for Serial Presence Detect, a chip residing on the memory module
that contains information about the size, speed, and other specifications of
the memory as well as manufacturer information that can be retrieved by
the motherboard through electronic signals.
c
Caution:
Before you install a memory module, be sure to discharge any
static electricity by touching a grounded piece of metal.
Otherwise, you may damage static-sensitive components.
w
Warning:
Be careful when working inside the printer as some components
are sharp and may cause injury.
1. Hold the memory module above the Memory slot and insert
it into the slot. Do not apply too much force.
24
Installing Options
Synchronous Dynamic RAM Dual In-line
Memory Module (SDRAM DIMM)
32 MB, 64 MB, 128 MB, 256 MB, or 512 MB
CL = 2
168-pin type, 64 bit, 3.3 V with SPD*
PC 100 compliant
Less than 40 mm