Bottom Cover - Sharp KB-6014LS Service Manual

KB-6014LS
KB-6014LK
KB-6014LW
AUTO DRAWER GEAR REMOVAL/INSTALLATION
(This procedure requires a 14" or greater phillips screwdriver)
1. Disengage any power going to the unit.
. Open the drawer and keep it open.
3. Remove the top cover and right side cabinet.
4. Unhook wiring to Auto Drawer Gear.
5. Remove bottom screw below Auto Drawer Gear (Fig. G-1).
6. Remove the (4) screws holding the auto drawer gear to the bottom cavity angle (Fig. G-2).
7. Disengage (pull) Auto Drawer Gear from rack gear and slide to the right (toward the rear), then turn motor 90
out along rear of drawer (Fig. G-3).
8. Then tilt Auto Gear Motor 0
Installation:
1. Proceed in reverse to reinstall the Auto Drawer Gear taking care that the gear teeth are set into the cavity angle correctly
Fig. G-2
RACK GEAR REMOVAL
1. Follow the Microwave Drawer disassembly as previously stated
. Open the drawer and keep it open.
3. To discharge the high voltage capacitor, wait for 60 seconds.
4. Remove the Microwave Drawer by following steps 1, , 5, 8, 9 & 10 as
instructed under "DRAWER ASSEMBLY AND CHOKE REMOVAL".
5. Remove the (3) screws holding the Rack Gear to the bottom slide rail
(Fig. G-5).
7. Proceed in reverse to reinstall the new Rack Gear.
Fig. G-5
o
to extract the assembly out. The Auto Drawer Gear is now free.

Bottom cover

Fig. G-1
Base plate
Fig. G-3
3
0
and slip
Bottom cover
Tilt
20 o
Fig. G-4